Before Installation - LIVARNO LUX HG03167D Montage-, Bedienungs- Und Sicherheitshinweise

DANGER OF SUFFOCATION! Children could swallow and choke on small
included parts (e.g. screws). Keep children away from the work area during
assembly.
The illuminants are not replaceable.
If the illuminants fail at the end of their lives, the entire product must be replaced.
Danger to life
by electric shock
Always check the product for damage before connecting it to the mains. Never
use the product if it shows any signs of damage.
Prior to installation, verify that the mains voltage on site corresponds with the
operating voltage required for the product (230 V∼ 50 Hz). Otherwise do not
install the product.
FIRE HAZARD! Fit the product so that it is at least 1.0 m away from
the material to be illuminated. Excessive heat can result in a fire.
1 .0 m
Only use 230 V∼ LED bulbs with a E27 base and a maximum output of 6 W.
Please note the LED bulb is not dimmable.

DANGER OF INJURY! Check any LED bulb for damage immediately after
unpacking. Do not fit a defective LED bulb into the product.
 
CAUTION! DANGER OF BURNS DUE TO HOT SURFACES!
Ensure the product has been switched off and allowed to cool before
you touch it. In this way you will avoid the danger of burns. LED bulbs
develop a great deal of heat.
Replace a defective bulb immediately. Before replacing the LED bulb always
remove the mains plug from the mains socket.
Allow the product to cool for at least 15 minutes before replacing a defective
LED bulb.

Before installation

Note: Remove all packaging materials from the product.
Important: The electrical connection must be established by a qualified electrician
or a person trained to perform electrical installations. This person must be familiar
with the properties of the product and the connection regulations.
8 GB/CY