Assembly And Installation - LIVARNO LUX 1002-W Bedienungs- Und Sicherheitshinweise

RISK OF INJURY! Incorrect handling of
„
the product may potentially result in
personal injury�
Any protective cover that is split or cracked
„
must be replaced�
Never look directly into the light source�
„
Never point the light into the eyes of other
„
people or animals�
PLEASE NOTE! Incorrect handling of the
„
light may lead to damage to the product�
Check the screw fixings at regular intervals.
z Assembly and installation
Please note: remove the product from its
packaging�
Check that all package contents are
„
present�
Check whether the outdoor spotlight or
„
individual parts are damaged� If that is the
case, do not use the outdoor spotlight�
Please contact the retailer via the service
address indicated on the warranty card�
Choosing the installation position
Fix the outdoor spotlight at a height of 2-3m
„
to a sturdy wall that is not subject to
vibration�
Only install the outdoor spotlight outside of
„
the hand-contact zone so as to prevent it
being touched�
Position it at least 20cm away from other
„
objects so as to ensure good ventilation�
If possible, mount the outdoor security in a
„
position where it will not be exposed to dirt
or dust and is protected from rain (e�g�
under a roof overhang), sun and other
weathering effects�
Take care to ensure that the outdoor
„
spotlight is not affected by interference from
another light source�
Do not point the motion sensor
„
heating fans, air conditioning units,
swimming pools or other objects with
rapidly changing temperatures�
10
GB
Do not point the motion sensor towards
„
trees, bushes or areas where moving
animals can be detected�
Take into account that the motion sensor
„
responds primarily to movement across its
field of view and not so sensitively to
movement directly towards or away from it�
Mounting the outdoor spotlight
RISK OF ELECTRIC SHOCK! Incorrect
electrical installation or a power supply
voltage that is too high can potentially cause
electric shocks� Failure to take account of
that risk endangers not only yourself but
other people as well�
You should only have the product installed
„
by a qualified electrician.
When drilling the fixing holes, take care to
„
avoid drilling through wiring, cables or
pipes (e�g� water or gas pipes)�
Make sure the power supply is
„
disconnected during installation� Switch off
the circuit-breaker for the circuit concerned
or remove the fuse� Safeguard it against
being switched on again (e�g� by
displaying a warning notice)�
Observe the correct polarity when
„
connecting the wires to the terminal strip
� Refer to Figure C for details of how to
6
connect the wiring/supply cable to the
terminals�
Make sure that the mains power supply is
„
switched off�
The outdoor spotlight can be mounted
„
either on a straight wall or on a corner
using the wall bracket
Please note: make sure that you mount the
wall bracket the correct way round� Refer to
Figure F for guidance�
With the wall bracket
„
mounting position, mark the positions on
towards the wall for the fixing holes using either the
2
guide holes
corner) or guide holes
straight wall) (see Figs� E and F)�
(see Fig� F)�
16
in its intended
16
(for mounting on building
18
(for mounting on
17