Operation; Turning On And Off; Checking The Battery Charge Level - FLORABEST FAT 18 B2 Originalbetriebsanleitung

Mounting.the.trimming.unit:
.
4. Slip the cutting disc (12) onto the
axle. There is only one mount-
ing position. Screw the cutting
disc (12) to the axle. Mind the
left-hand thread. Please ensure
that the screws are properly tight-
ened.
Place the cutting insert (13) on
the pin (23) on the cutting disk
(12) and pull out the insert until it
snaps in.
Spare cutting inserts are kept in the
box (4) on the auxiliary handle (5).
To.insert.the.battery:
5. To insert the battery (16), place it
on the guide track (20) and push
it into the appliance. It will audi-
bly snap in.

Operation

. Caution:.risk.of.injury!.Do.not.
operate.the.appliance.with-
out.the.protective.cover..To.
operate.the.appliance,.wear.
suitable.clothing,.eye.and.ear.
protection..
. Prior.to.every.use,.check.that.
the.appliance.is.operative..Do.
not.block.the.On/Off.switch.
or.the.switch.lock..They.must.
reliably.turn.off.the.motor.
when.you.release.the.switch..
Do.not.operate.the.appliance.
if.one.of.the.switches.is.dam-
aged.
Please observe local regulations
concerning noise protection.

Turning on and off

Maintain a firm stand and hold the
appliance well with both hands and
at some distance away from your
body. Before turning on the appli-
ance, check that it will not touch
any objects.
1. Check that the battery (16) is in
(see "Assembly instructions - In-
serting the battery").
2. To turn on, use your thumb to
actuate the switch lock (3), then
press the On/Off switch (2). Re-
lease the switch lock.
3. To turn off, release the On/Off
switch (2). There is no continuous
operation mode.
. After.turning.off.the.appli-
ance,.the.trimming.assembly.
will.keep.revolving.for.some.
time..Allow.the.trimming.as-
sembly.to.come.to.a.stand-
still..Neither.touch.nor.slow.
down.the.moving.cutting.in-
sert..Risk.of.injury!
Checking the battery charge
level
The battery's ( 18) charge level is indi-
cated by the charge state indicator (
16).
Press the PRESS button on the battery.
The LEDs indicate the battery's charge
level.
Recharge the battery when the last
charge state indicator LED (
changes from green to orange/red.
GB
18)
13