Introduction; Intended Utilisation; Fittings; Items Supplied - Parkside PES 200 B1 Bedienungs- Und Sicherheitshinweise

Introduction

Electric Scraper PES 200 B1
Introduction
Q
We congratulate you on the purchase of your new
device. You have chosen a high quality product.
The instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as descri-
bed and for the specified applications. If you pass
the product on to anyone else, please ensure that
you also pass on all the documentation with it.

Intended Utilisation

Q
The appliance is suitable for the removal and abra-
sion of coverings such as carpets, felts, cork sheets
and plaster on small areas. It is also intended for
removing residues of adhesives, paints and fillers,
for the smoothing of coarse surfaces as well as for
carvings on soft woods. Any other use of, and
modification to, the appliance is deemed to be
improper usage and may result in serious physical
injury. The manufacturer declines to accept respon-
sibility for damage(s) arising out of usage contrary
to the instructions specified below. The appliance is
not intended for commercial application.

Fittings

Q
ON / OFF switch / Stroke rate preselector
1
Tool arrestor
2
Tool receptor
3
Tool attachment
4
Knife / Scraper attachment (offset)
5
Knife / Scraper attachment (straight)
6
Spatula attachment
7
Chisel attachment
8
Carving chisel attachment
9
30 GB

Items supplied

Q
1 Electric Scraper PES 200 B1
1 Knife / Scraper attachment (offset)
1 Knife / Scraper attachment (straight)
1 Spatula attachment
1 Chisel attachment
1 Carving chisel attachment
1 Operating manual

Technical Data

Q
Rated voltage:
Nominal power consumption: 200 W
Nominal stroke rate:
Stroke:
Protection class:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1.5 m / s
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
230 V ~ 50 Hz
Level I: n 6500 min
0
Level II: n 7500 min
0
Level III: n 8500 min
0
ca. 2 mm
II /
77.50 dB(A)
88.50 dB(A)
3 dB
= 2.066 m / s
2
2
-1
-1
-1