Commissioning; Working Notices; Switching On / Off; Selecting The Stroke Rate - Parkside PES 200 B1 Bedienungs- Und Sicherheitshinweise

Commissioning / Maintenance and cleaning / Service centre

Commissioning

Q

Working Notices

Q
A lways work away from the body.
H old the appliance with both hands (see Fig. B).
I ntroduce the attachment tool
or the area to be worked with the appliance
switched on. In that the working motion of the
appliance first takes place on contact with the
material, you will achieve a much more accu-
rate positioning of the attachment tool.

Switching ON / OFF

Q
Notice: The working motion of the appliance first
takes place on material contact.
Switching on:
P ush the ON / OFF switch / Stroke rate prese-
lector forwards.
1
Switching off:
P ush the ON / OFF switch / Stroke rate prese-
lector backwards.
1

Selecting the stroke rate

Q
Note: The optimal stroke rate is dependant on
the material or the surface to be worked. It is best
determined by simple trial and error. Always start
off with the lowest setting. Should the removal be
too slight, increase the stroke rate level for level.
S lide the ON / OFF switch / Stroke rate prese-
lector to the front to increase the stroke rate.
1
Level 1: low stroke rate for precision work
Level 2: moderate stroke rate
Level 3: highest stroke rate for fast removal
S lide the ON / OFF switch / Stroke rate prese-
lector to the rear to decrease the stroke rate.
1
34 GB
Q
The best work results are only achieved with sharp
attachment tools. You should thus resharpen them
in good time.
to the material
4
the plug from the power socket before beginning
to sharpen the tools.
On a belt sander (e.g. Parkside PBS 600 A1
see Fig. H):
Q
the device always pull the mains lead out of the
mains socket.
Q
Resharpening the
attachment tools
RISK OF INJURy! Remove
P lace the attachment tool
into the Electric scraper (see section on
"Changing attachments").
A ppropriately fasten the belt sander into / onto
a suitable stationary facility.
P ay attention to the running direction of the belt
on the belt sander when resharpening.

Maintenance and cleaning

Before you clean or maintain
A lways keep the device clean, dry and free of
oil or grease.
R egularly clean the tool receptor
C lean the attachment tools of all remains of
adhesives and other grime.
L iquids may not be permitted to permeate into
the appliance.
U se a soft, fluff-free cloth to clean the housing.
N ever use fuel, solvents or aggressive cleansers
that could damage plastic.

Service centre

Have your device re-
paired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
to be sharpened
4
.
3