Briggs & Stratton 100600 Bedienungsanleitung Seite 7

• To reduce risk of damage to electric plug and cord, pull by plug rather than cord
when disconnecting charger.
• Do not operate charger with damaged plug or cord. The supply cord cannot be
replaced. If the cord is damaged, the charger should be replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way. If charger is damaged it must be replaced. Charger is not
serviceable.
• Do not disassemble charger; or attempt to service.
• To reduce risk of electric shock, unplug charger from outlet before cleaning.
• Do not short circuit; never place any object into the battery contacts.
• The charger is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the charger.
Extension Cord
• An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If an extension cord
must be used, make sure that; a. pins on plug of extension cord are the same
number, size, and shape as those of plug on charger, b. extension cord is properly
wired and in good electrical condition, and c. wire size is a minimum of 16 AWG
(American Wire Gauge) to allow for AC ampere rating of charger.
When Storing Battery Pack
• Keep battery pack and battery charger dry. Do not expose battery pack or charger
to rain or wet conditions.
Before Performing Adjustments Or Repairs
• Remove battery pack from engine battery tray.
WARNING
Battery chemicals are toxic and corrosive.
Fire or explosion can cause severe burns or death.
• Never burn or incinerate discarded or used battery packs as they may explode.
Toxic fumes and materials are created when battery packs are burned.
• Do not use a battery that has been crushed, dropped, or damaged.
Features and Controls
Engine Controls
Compare the illustration (Figure: 1, 2, 3, 4) with your engine to familiarize yourself with the
location of various features and controls.
A. Engine Identification Numbers Model - Type - Code
B. Engine Serial Number
C. Electric Starter
D. Fuel Tank and Cap
E. Air Cleaner
F. Lithium-Ion Battery Pack
G. Dipstick
H. Oil Drain Plug
I. Muffler, Muffler Guard (optional), Spark Arrester (if equipped)
J. Throttle Control (if equipped)
K. Fuel Filter (if equipped)
L. Air Intake Grille
M. Battery Charger
N. Spark Plug
Engine Control Symbols and Meanings
Symbol Meaning
Engine speed - Fast
Engine speed - Stop
Engine start - Choke ON
Fuel
Battery Control Symbols and Meanings
Symbol Meaning
Volt
Double Insulated
Direct Current
Underwriters Laboratories,
Inc. Registered Product
Operation
Oil Recommendations
Oil Capacity: See the Specifications section.
We recommend the use of Briggs & Stratton Warranty Certified oils for best performance.
Other high-quality detergent oils are acceptable if classified for service SF, SG, SH, SJ or
higher. Do not use special additives.
Outdoor temperatures determine the proper oil viscosity for the engine. Use the chart to
select the best viscosity for the outdoor temperature range expected.
Symbol Meaning
Engine speed - Slow
On - Off
Engine start - Choke OFF
Symbol Meaning
Ampere
Alternating Current
Underwriters Laboratories, Inc.
US & Canada Listed Product
Hertz
Charge Battery Pack
Remove Key / Battery Pack
7