Redmond RMK-M451 Bedienungsanleitung Seite 18

For safety reasons use tongs when changing the position of the heating element (included in set).
Be sure to use a thermal glove for gripping the tongs. Do not touch the heating disc regardless of the position it's in!
To fix the heating element into the upper position carefully lift it until tight and slightly turn counterclockwise until secure fixation
of the mounts in the slots on the walls of the working chamber. To place the disc heating element into the lower position slightly
lift it, so that its mounts exit slots on the walls of the working chamber, and, having turned the disc clockwise, carefully lower it.
Do not try to change the position of the heating element if the appliance is plugged in!
Do not close the lid if the disc heating element is set to an upper position.
For cooking in the appliance use only REDMOND FP-C501 frying pan, included in set.
"MASTERCHIEF LITE"
Discover more possibilities for culinary creativity with the new "MASTERCHIEF LITE" function! While "МУЛЬТИПОВАР" allows
setting a programme parameters before it starts, then "MASTERCHIEF LITE" allows adjustments during the cooking process.
You can always adjust any programme, so that it corresponds to you wishes. Does your soup boil over? Does your oatmeal
"escape"? Are your vegetables steamed for too long? Adjust the cooking temperature or time, without interrupting a cooking
programme as if you cook on the stove or in the oven.
You can use "MASTERCHIEF LITE" only during cooking. "MASTERCHIEF LITE" is not applicable for "ЭКСПРЕСС", "Time Delay"
and waiting to access operating parameters.
When using "MASTERCHIEF LITE" the temperature can be adjusted between 35 and 170°С with 1°C increments. Possible
cooking time range on the selected programme with 1 minute increments.
"MASTERCHIEF LITE" can be very useful especially when you cook meals on complex recipes, requiring combination of different cooking
programmes (e.g. cooking cabbage rolls, beef stroganoff, soup and different types of pasta, jam, etc.).
To adjust cooking temperature:
1. Press the "Меню" button during cooking. The temperature value indicator will be flashing.
2. Set the desired temperature. To increase the value press the "Час/+" button, to reduce the value press the "Min/—"
button. Press and hold the corresponding button down to scroll through the digits.
3. After the maximum (minimum) value is reached the adjustment starts again. Do not press the buttons on the control
panel for 5 seconds. Settings will be saved automatically.
For overheat protection when setting the cooking temperature higher than 130°С the maximum programme operating
time is limited to two hours (except for "ВЫПЕЧКА"). Cooking temperature adjustment is not applicable for "ЙОГУРТ"
programme.
To adjust cooking time:
1. Press the "Меню" button twice during cooking. Time value indicator will be flashing.
2. Set the desired cooking time. To increase the value with 1 hour increments press the "Час/+" button, to increase the value
with 1 minute increments press the "Min/—" button. The hour value changes irrespective of the minute value. After the maximum
value is reached the adjustment starts again. Press and hold the corresponding button to scroll through the digits.
3. Do not press the buttons on the control panel for 5 seconds. Settings will be saved automatically.
When setting cooking time value to 00:00, the programme operation will be stopped.
Standard Operating Procedure for Automatic Programmes
IMPORTANT! If you use the device to boil water (for example, when cooking foods), DO NOT set the cooking temperature
above 100°C. It can cause overheating and failure. For the same reason, DO NOT use the programs «ВЫПЕЧКА», «ЖАРКА»,
«ХЛЕБ» to boil water.
1. Prepare (measure) the ingredients.
2. Fill the appliance bowl with ingredients according to the cooking programme and position it inside the appliance.
Ensure that all ingredients are evenly spread below the maximum fill mark on the inside of the bowl. Ensure that
it has full contact with the heating element.
3. Close the main lid until it clicks into place. Plug in the appliance.
ATTENTION! If you cook at high temperatures with much oil, always keep the lid open.
18
4. Use the "Меню" button to resume from standby mode. Use the "Час/+" and "Mин/–" buttons to select a programme (the
corresponding programme indicator will be flashing). Press the "Меню" button again to confirm the programme selection.
"МУЛЬТИПОВАР" enables to set the desired cooking temperature. Use the "Час/+" button to increase the default value,
"Mин/–" button to reduce the value. Press the "Меню" button to finish the temperature setting.
5. Use the "Час/+" and "Mин/–" buttons to adjust default cooking time.
6. Set time of delay if necessary.
"Time Delay" is not applicable for "ЖАРКА", "МАКАРОНЫ" and "ЭКСПРЕСС" programmes.
7. Press the "Старт" button to begin cooking. The "Старт" and "Отмена/Разогрев" indicators will light up solid. Depending
on the selected programme, the timer will begin countdown after pressing the "Старт" button or upon reaching the
required temperature in the bowl.
The "Keep Warm" function can be disabled in advance by pressing the "Старт" button. The "Отмена/Разогрев" indicator will go
out. Press the "Старт" button again to enable this function. "Keep Warm" is not applicable for "ЙОГУРТ" and "ЭКСПРЕСС" programmes.
8. An audible signal will be produced to indicate that cooking is complete, the End indicator will light up on the display.
Depending on the selected programme or current settings the appliance will either enter the "Keep Warm" mode (the От-
мена/Разогрев and "Keep Warm" indicators are lit on the display) or the Standby mode.
9. To cancel a programme, to interrupt cooking or the "Keep Warm" function, press and hold the "Отмена/Разогрев" button.
To achieve a good result refer to the recipes included in the REDMOND RMK-M451 cookbook, designed specifically for this
model. You can also find corresponding recipes on www.multicooker.com.
If you failed to achieve the desired result using standard automatic programmes, use "МУЛЬТИПОВАР" programme, that
provides great opportunities for your culinary experiments.
"МУЛЬТИПОВАР" Programme
The programme allows cooking time and temperature adjustment according to your needs. "МУЛЬТИПОВАР" enables the
REDMOND RMK-M451 multikitchen to function as a number of kitchen appliances and to cook any recipe found on the
Internet or in a family cookbook.
If the cooking temperature does not exceed 80°С, the "Keep Warm" function will be disabled without possibility of manual switching.
Default cooking time of the programme is 30 minutes; default temperature is 100°С. The temperature can be manually
adjusted between 35 and 170°С in 5°С increments, the time between 2 minutes and 15 hours in 1 minute increments.
ATTENTION! For security purposes if the temperature is set to more than 130°С the cooking time will be limited to two hours.
The "МУЛЬТИПОВАР" programme enables to cook a wide variety of dishes. Use the attached cookbook by our professional
chefs or the table of recommended temperature for cooking different dishes and products. You can also find necessary
recipes on www.multicooker.com.
If you use the "МУЛЬТИПОВАР" programme to boil water (for example, when cooking foods), it is PROHIBITED to set the
cooking temperature above 100°C.
"ПЛОВ" Programme
The programme is recommended for cooking different rice pilaf. Default cooking time of the programme is 35 minutes. The
time can be manually adjusted between 10 minutes and 2 hours in 5 minute increments.
"НА ПАРУ" Programme
The programme is recommended for steaming meat, fish, poultry, vegetables and multicomponent steamed dishes. Default
cooking time of the programme is 30 minutes. The time can be manually adjusted between 10 minutes and 2 hours in 5
minute increments. Use the steaming busket, provided with the appliance, to steam meals:
1. Fill the bowl with 400–800 ml of water. Position the steaming busket inside the appliance.
2. Measure and prepare ingredients according to the recipe directions and evenly distribute them inside the busket.
Position the bowl inside the appliance. Ensure that it has full contact with the heating element.
3. Follow the instructions indicated in paragraphs 3-8 of the Standard Operating Procedure for Automatic Programmes".
An audible signal will be heard after water comes to a boil and sufficient amount of steam is generated in the bowl. The programme
time will start to count down.
In case you don't use automatic time settings in this programme refer to the "Recommended Steaming Time for Different Meals" table.