Lubricant Distribution Within The Metering Device; Phase 1 + 2; Phase 3 - 5 - Lincoln Quicklub SSV Benutzerinformation

User Manual
Operating Instructions

Lubricant Distribution within the metering Device

The 5 f ollowing illustrations show the piston movements and
the depending lubricant distribution to the individual outlets.
NOTE
The illustrations fig. 17 to 21 show the
sequence of delivery only of outlets 2, 7, 5,
3 and 1. The delivery of the residual out-
lets 8, 6 and 4 is derived from the logical
6 001a02
pumping until the complete divider cycle
has finished. The f unctional principle of
SSV is identical with SSV M metering
devices.
Fig. 17 Phase 1
Fig. 18 Phase 2
Page 12 of 24
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Operation, continuation
When the lubricant supply is interrupted
- the pistons come to a halt;
- the lubricant is no longer dispensed to the lubrication
When the lubricant is fed again to the metering device, the
cycle begins from the point where it had been interrupted.
Phase 1
The lubricant enters the metering device from above
(white arrow) and flows to the right-hand end of piston A.
Piston A (black arrow) is moved to the left under the pres-
sure of the lubricant, causing the lubricant ahead of the
left-hand end of piston A to be dispensed to outlet 2
(dashed arrow).
2007a9 9
Phase 2
Once piston A has reached its left-hand final position, the
junction channel to the right-hand end of piston B is
opened.
The lubricant which arrives from above (white arrow) also
moves piston B (black arrow) to the left, causing the lubri-
cant quantity ahead of the left-hand end of piston B to be
dispensed to outlet 7 (dashed arrow).
2008a9 5
point.
Lubricant under pump pressure
Lubricant under delivery pressure of the piston
Lubricant, pressureless
Lubricant under pump pressure
Lubricant under delivery pressure of the piston
Lubricant, pressureless
2.2EN-20001-I11