Troubleshooting - Parkside PMTS 210 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

16. Troubleshooting

Fault Possible causes
Blade dissolves after To slightly tightened fastening nut
switching off the engine
Engine will not start Failure mains fuse
Defective extension cable
Connections on motor or switch not in order
Motor or switch faulty
Motor will not work, the Cross section of the extension cable is not
fuse is active sufficient
Overload by a blunt saw blade
Fire marks on the cutting Blunt saw blade
surface
Wrong saw blade
30 GB
Action
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
See „Electrical connection"
Change saw blade
Have saw blade sharpened (only by an authorised
sharpening specialist) or change it
Change saw blade