Troubleshooting; Possible Cause - Parkside PMTS 210 A1 Originalbetriebsanleitung

17. Troubleshooting

Fault

Possible cause

Saw blade is loose after Fixing nut not tight enough
the motor is switched off
Motor does not start Mains fuse blown
Extension cable defective
Connection to the motor or switch not OK
Motor or switch faulty
Motor not supplying Cross section of the extension cable insufficient
power, fuse tripping
Overload due to blunt saw blade
Burnt areas on the Blunt saw blade
cutting surface
Incorrect saw blade
62 GB/MT
Remedy
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Have this checked by an electrician
Have this checked by an electrician
see "Electrical connection"
Replacing the saw blade
Sharpen saw blade (only by an authorised sharpening
service) or replace
Replace saw blade