Restoring The Default Settings - VOLTCRAFT GM-70 Bedienungsanleitung

The serial data signal is made up of 16 bits in the following order:
D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
D15 Start signal
D14 4
D13 1
D11+D12 United of measurement on the display: B5 = G, E3 = mT
D10 Polarity; 0 = positive, 1 = negative
D9 Decimal point (DP) at the corresponding point from right to left; 0 = no decimal point
1 = 1 decimal point
2 = 2 decimal points
3 = 3 decimal points
D8 to D1 Measured value D8 = largest figure (MSD), D1 = lowest figure (LSD). If 1234 is displayed, the
bit rate is: '00001234'
D0 End signal
RS232 port
Baud rate: 9600
Parity No parity
Number of data bits Number of data bits
Stop bit 1 stop bit
g) Restoring the default settings
If you experience problems with the measuring device, for example, in the event of a system freeze, reset the device.
Proceed as follows:
• Open the side flap. See Section 'f) RS232 interface'.
• When the measuring device is switched on, press the RESET button (9) with a pointed object. All previous settings
are reset set to the default values. The settings may need to adjusted again.
31