Replacing The Fuse; Maintenance And Care; Warranty And Service Information; Warranty Terms - ULTIMATE SPEED ULG 12 A2 Originalbetriebsanleitug

Operation / Maintenance and care / Warranty and service information
Connect the black connector clamp
negative battery terminal. (The negative terminal
is marked with a "-" symbol and a black mark.)
If the connector clamps are connected correctly,
the car charger will automatically select the cor-
rect battery type. You may review it in the "Bat-
tery Type" option field and if necessary change
it by pressing the battery type button
Now select the "Start" function using the Charge
Start button . The cart charger will now ana-
3
lyse the battery's charge level. The display will
now read "0".
Start the vehicle's ignition. The display will now
show a 5 second countdown (of which 2 second
priming / analysis function and 3 second jump
start function at 75 A) when needing the car
charger for jump starting (previously analysed
by the car charger). During this countdown the
car charger will briefly deliver 75 A to bridge
the battery to start the car. This is followed by
a 180 second pause to protect the battery. The
cycle will now restart (2 second priming / anal-
ysis function and 3 second jump starting at
75 A / 180 second pause).
To disconnect the device, first remove the termi-
nal clamps ( /
6 7
cord .
9
Note: If the battery is completely drained, the 75 A
will not be sufficient to start all engines (e.g. diesel
vehicles).
In this case, please select the "Fast Charge"
option using the Charge Start button
charge the battery 60 % (preheating of diesel
engines draws power from the battery. This re-
quires 60 % after preheating).
You can monitor the charging process in the display
by selecting the "Battery %" option using the digital
display button .
1
Once 60 % has been reached, jump start again.
Attention: Exit the mode by unplugging the
mains cable .
9
12 GB
to the
6
.
2
) and unplug the power
and
3

Replacing the fuse

The car charger fuse can be damaged by e.g. hard-
ware failure, overload, etc.
Unplug the power cord
the fuse.
Remove the fuse
4
in the side.
Unscrew the fuse
4
spanner and secure the new fuse.
Then screw it tight and replace the cover
Note: If you need a new fuse, please contact
our service department (see chapter Warranty
and Service Information).

Maintenance and care

Always unplug the power cord
socket before working on the car charger.
The device is maintenance-free. Switch off the
device. Clean the device's metal and plastic with
a dry cloth.
Never use solvents or other abrasive cleaners.
Warranty and service
information
Creative Marketing Consulting GmbH
warranty
Dear customer,
the warranty for this device is 3 years from the date
of purchase. In the event of product defects, you
have legal rights against the retailer of this product.
Your statutory rights are not limited in any way by
our warranty detailed below.

Warranty terms

The warranty period begins on the date of purchase.
Please retain the original receipt safely.
This document is required as your proof of purchase.
Should this device show any defect in materials or
before replacing
9
cover by slightly pressing
with a fitting open-end
4
from the mains
9
.