Alternator Test Function; Replacing The Fuse; Maintenance And Care; Warranty And Service Information - ULTIMATE SPEED ULG 15 B4 Originalbetriebsanleitung

Operation / Maintenance and care / Warranty and service information
Attention: End the mode by pulling the
mains plug 7 .
z Alternator test function
Connect the mains cable
„ „
charger to the socket.
Attach the red connection terminals
„ „
to the plus pole of your battery. (The plus
pole is marked by a "+" and a red mark.)
Attach the black connection terminals
„ „
to the minus pole of your battery. (The mi-
nus pole is marked by a "+" and a black
mark.)
Set the function alternator (LED next to the
alternator) via the button
played. Start the engine. If the % - value rises
with the engine running, the alternator will
charge the battery. If the % - value drops or
remains the same, there is a problem with the
alternator, the connection or the battery.
Disconnect the device from the mains
„ „
current.
Disconnect the "–" - pole quick contact-
„ „
connection terminal (black)
"–" - pole of the battery.
Disconnect the "+" - pole quick contact-
„ „
connection terminal (red)
"+" - pole of the battery.
Reconnect the plus pole connection cable
„ „
of the battery to the plus pole of the bat-
tery.
Reconnect the minus pole connection ca-
„ „
ble of the battery to the minus pole of the
battery.
z Replacing the fuse
The fuse of the car charger may be dam-
aged, e.g. by a device defect, overload, etc.
Before replacing the fuse, pull the mains
„ „
cable 7 .
14 GB/IE/NI
7
of the car
5
4
1
. A % - value is dis-
4
from the
5
from the
Remove the cover of the fuse
„ „
pressing it slightly on the side.
Unscrew the fuse with a matching
„ „
open - faced wrench and attach the new
fuse.
Screw it on subsequently and replace the
„ „
8
cover .
Note: If you need a new fuse, contact our
service (see chapter with notes on guarantee
and service processing).
z Maintenance and care
Always pull the mains cable
„ „
socket before you perform any work at the
car charger.
The device is maintenance - free. Deacti-
„ „
vate the device. Clean the metal and plas-
tic surfaces of the device with a dry cloth.
Never use any solvents or other aggres-
„ „
sive cleaning agents.
z Warranty and service
information
Creative Marketing &
Consulting GmbH warranty
Dear customer,
The warranty for this equipment is 3 years
from the date of purchase. In the event of
product defects, you have legal rights against
the retailer of this product. Our warranty,
outlined below, does not limit your statutory
rights.
z Warranty conditions
The warranty period begins on the date of
purchase. Please retain the original sales
receipt.
This document is required as your proof of
8 by de-
7
from the