Cleaning; Air Filter; Spark Plug; Petrol Filter - Parkside PSE 2800 B2 Bedienungs- Und Sicherheitshinweise

Cleaning, maintenance, storage, transport and ordering replacement parts
ATTENTION! Turn the device off imme-
diately and contact your Service Station:
- With unusual vibrations or noises.
-
If the engine seems overloaded or has backfired.

Cleaning

Keep the safeguards, air vents (fig. B / Pos. B1)
and the engine housing as dust and dirt free as
possible. Wipe the device with a clean cloth or
blow it with compressed air with low pressure.
We recommend that you clean the device after
every use.
Regularly clean the device with a damp cloth
and a little soft soap. Do not use any cleaning
products or solvents which could attack the plas-
tic part of the device. Ensure that no water can
penetrate the housing.

Air filter

Also refer to the service information.
Clean the air filter regularly, and if necessary
exchange it.
Open both brackets (fig. K / Pos. K1) and remove
the air filter lid (fig. K / Pos. K2).
Remove the filter element (fig L / Pos. L1).
When cleaning the element do not use any strong
cleaners or petrol.
Clean the element by tapping it on a flat surface.
If it is very dirty wash with soapy water, rinse
with clean water and leave to dry.
Put it back together in the opposite order.
Spark plug (fig. M–N)
Check the spark plug
27
use for dirt and if necessary clean it with a copper
wire brush. Then service the spark plug after every
50 hours of use.
Remove the spark plug connector
with a turning movement.
Remove the spark plug
plug socket included.
25
Put it back together in the opposite order.
after the first 20 hours of
(fig. M)
28
(fig. N) with the spark
27
Note: alternative spark plugs to F7RTC:
Bosch WR7DC
Petrol filter (Fig. A)
Note: The petrol filter
directly under the petrol cap
added.
Turn the ON /O FF switch
position.
Open the petrol cap
Remove the petrol filter
non-flammable solvent or solvent with a high
tlash point.
Reinsert petrol filter
Close the petrol cap
Changing the oil, checking the
oil level (before each use)
Changing the oil should take place when the engine
is warm.
Only use engine oil (15 W–40).
Put the generator on a suitable mat, slightly
tilted towards the oil drain plug
Open the oil fill plug
Open the oil drain plug and pour the warm
engine oil into a collection tank.
After pouring out the old engine oil, close the
oil drain plug and put the generator upright.
Pour in engine oil up to the top mark on the
dipstick (approx. 0.6 l).
ATTENTION! When checking the oil level
with the dipstick (oil fill plug) do not screw it
on, just plug it in until the threads.
The old oil must be disposed of according to
the regulations.

Low oil switch off

The low oil switch-off responds, if there is not enough
engine oil. In this case, the engine will not start or
switches off automatically after a short period of
operation. A restart will only be possible after
is a filter bowl located
5
, filtering any petrol
1
to the "OFF"
11
.
1
and clean in a
5
.
5
.
1
.
9
.
8
GB 11