Preparation For Storage; Preparation For Transporting; Ordering Spare Parts; Disposal - Parkside PSE 2800 B2 Bedienungs- Und Sicherheitshinweise

Cleaning, maintenance, storage, transport ... / Disposal / Troubleshooting guide
topping-up the oil level (see Chapter "Oil change,
checking the oil level (before every use)").

Preparation for storage

Empty the petrol tank with a petrol suction pump.
Start the engine and leave it running until the
rest of the petrol has been used up.
Change the oil after each season. To do this,
remove the old oil from the warm engine and
refill with new oil.
Remove the spark plug (fig. N). Fill about 20 ml
of oil into the cylinder using an oil can. Slowly
pull the express start so that the oil protects the
cylinder from the inside. Screw the spark plug
back in.
Store the device in a well ventilated place or
area.

Preparation for transporting

Empty the petrol tank with a petrol suction pump
or alternatively using the petrol tap and a suita-
ble canister.
Once it it ready for use, leave the engine running
until the rest of the petrol has been used up.
Empty the engine oil from the engine (as de-
scribed).
Remove the spark plug connector (Fig. M) from
the spark plug.
Secure the device with a tension belt to prevent
it slipping out of place.

Ordering spare parts

When ordering replacement parts you should give
the following information:
Type of device
Device article number
Device ID number
Find current information at
www.kompernass.com
12 GB
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.

Disposal

made of environmentally friendly materi-
als. It can be disposed of at your local
recycling centre.
electric equipment in the household waste!
According to European Directive 2012 / 19 / EU,
used electrical devices must be collected and recy-
cled in an environmentally friendly manner.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out devices.
Never pour away residual petrol but must be prop-
erly stored / disposed.
For information on proper petrol disposal or dispos-
ing of your device, please contact your municipal
administration.

Troubleshooting guide

Fault Cause
Engine does Automatic oil
not start cut-out has not
responded
Spark plug
fouled
No fuel
The packaging is
Do not dispose of
Remedy
Check oil level,
top up engine oil
Clean or replace
spark plug
(electrode
spacing 0.6 mm)
Refuel / have
the petrol cock
checked