Changing The Tines; Storage - FLORABEST FGH 710 A1 Originalbetriebsanleitung

• Remove any soil and dirt residues stuck
to the tines (11), driveshaft (10), tool
surface and vents (7) with a brush or
dry cloth.
• Spray or rub biodegradable oil into
the tines (11).
• Clean soiled grips with a damp cloth.
• Always check the tool for obvious dam-
age such as loose, worn or damaged
parts before using it. Check that all
nuts, bolts, and screws are tight.
• Check the covers and guards for dam-
age and correct fit. Change them if
necessary.

Changing the tines

The tool is fitted with four tine wheels that
can easily be changed in pairs. Both of the
tine-wheel pairs can be fitted on the left or
right, as required.
Always change both tine
pairs at the same time to
avoid damage to the tool
from imbalance.
Switch the tool off, unplug it and
wait for the tines to stop turning.
D
1. Unscrew the hex bolt (19) and
the self-locking nut (20) on the
tine-wheel pair (11).
2. Slide the tine-wheel pair off the
shaft (10).
3. Clean the driveshaft with biologi-
cal oil.
4. Slide the new tines onto the
driveshaft with the holes on the
axles aligned to the holes on the
driveshaft (see
Œ
D
).
Make sure that the tines are set to
their proper turning direction. The
arrows on the gearbox and tines
should point the same way (see

).
5. Slide the hex bolt through the
hole and tighten on the self-lock-
ing nut (supplied with each new
tine wheel pair (see

Storage

• Leave the motor to cool down before
you put the tool into a closed space.
• Keep the tool clean, dry and out of the
reach of children.
• Do not cover the tool in plastic bags as
moisture may form.
Unscrew the wing nuts
E
and fold the fork grips down to re-
duce the space taken by the tool.
The frame tubing (6) also serves as
a hook to hang up the tool at the
place of storage.
Make sure that the cable does not
become jammed.
Do not use the tool with the
handle folded closed. There is
a risk of injury!
GB MT
D
Ž
D
)).
37