Installation; Assembling The Pan-Tilt Head - Panasonic AW-PH405E Handbuch

Installation

w Assembling the pan-tilt head
When assembling the pan-tilt head, use the hexagon key wrench provided and a screwdriver to tighten up the parts at
the specified torque.
After mounting the pan-tilt head, check there is no play in its installation.
Attaching the camera mounting base
Attach the camera mounting base to the rotary arm using the
3 mounting screws (M5 M 22 mm, with flat washers, spring
washers) provided. The installation direction differs depending
on how the base is installed.
Attaching the rotary arm
Attach the rotary arm to the rotary head using the 4 mounting
screws (M5 M 22 mm, with flat washers, spring washers)
provided. The installation direction differs depending on how the
arm is installed.
For a stand-alone installation
Camera mounting base
For installation on the ceiling
p Change the guide pin and screw positions as shown in the figure below on the right, and then attach the camera mounting
base to the rotary arm.
p Tighten up the guide pins using a flathead screwdriver.
Rotary head
(Be sure to ask your dealer to install the unit.)
Rotary arm
Rotary arm
Camera mounting base
Attaching the base
and arm
Mounting screws (M5)
Guide pins (M4)
Rotary head
Camera mounting base
Change the positions of the
camera mounting screws.
11 (E)
Clamping torque
3.0 N m (30 kgf cm)
• •
1.5 N m (15 kgf cm)
• •
Change the positions
of the guide pins.