Installation Precautions - Panasonic AW-PH360L Bedienungsanleitung

Installation precautions

O Do not install the pan/tilt head on any of its sides.
OAvoid using the pan/tilt head in kitchens or other places where there is excessive steam
and oil fumes.
OMake sure that the installation of the pan/tilt head has been completed before mounting
the camera onto it.
OThis pan/tilt head has a maximum load capacity of 4 kg.
Do not use it for loads over 4 kg.
ODo not use a lens that will cause the camera to be poorly balanced. Such a lens should
not be used even if the load capacity is under 4 kg.
ODo not install the pan/tilt head outdoors or in any place where the temperature is over
45°C or below –10°C.
Further, it should be used where the ambient humidity is less than 90%.
OScrews for mounting the pan/tilt head are not provided with the stand and must therefore
be purchased separately.
They should be selected with due consideration given to the location where the pan/tilt
head is to be mounted and its load capacity.
OTo supply power to the pan/tilt head, use only the AC adapter (AW-PS300A) designed
for use with this pan/tilt head. The pan/tilt head cannot be powered by batteries or any
other source of power.
OWhen handling the pan/tilt head, be sure to hold it by the base.
Do not lift the pan/tilt head by the head or tilting arm.
Doing so may cause the unit to malfunction.
ODo not turn the head or tilting arm by hand.
Doing so may cause the unit to malfunction.
ODropping the pan/tilt head or subjecting it to a strong shock may cause malfunctioning or
an accident.
OInstall the pan/tilt head so that a clearance of at least 1 m is left around the monitor.
OWhen mounting a camera onto the pan/tilt head, take due care to prevent the camera
from slipping out of position or dropping.
OInstall the pan/tilt head and set the limiters so as to ensure that none of the components
mounted on the pan/tilt head or cables will make contact with any other objects in the
vicinity when the pan/tilt head rotates.
- 4 (E) -