Specifications; Supply Voltage - Panasonic AW-PH405E Handbuch

Specifications

Supply voltage:

Power consumption: 120 W
indicates safety information.
Genlock input:
Prompter input
(PROMPTER IN):
Prompter output
(PROMPTER OUT):
Camera video output
VIDEO:
Y:
Pr/C:
Pb:
SDI:
AUX:
Camera, pan-tilt head control:
RP
Functions/performance:
Ambient operating temperature: –5 °C to +45 °C
Storage temperature:
Ambient operating humidity:
Dimensions (W V H V D):
Mass (weight) :
Finish:
Mass (weight) and Dimensions indicated above are approximate.
Specifications are subject to change without notice.
AC 220 to 240 V, 50 Hz
BNC
Black burst or composite video signal, Tri Sync
BNC
Through output to PROMPTER connector
D-SUB 15-pin
BNC, 75-ohm output
BNC, 75-ohm output
BNC, 75-ohm output
BNC, 75-ohm output
BNC
BNC
RJ45, RS-422, pan-tilt head control signal output
Connecting cable: 10BASE-T straight cable (equivalent to UTP category 5),
max. 1000 meters
Maximum load: 15 kg
p In the event that the drop-prevention wire provided with the pan-tilt head is used to prevent
dropping, the maximum load when the pan-tilt head is used in combination with the
camera and lens is 5 kg or less. If the load exerted by the units to be installed exceeds
5 kg, measures to sufficiently withstand this load must be taken to prevent the units from
dropping.
Tilt range: 300 ° (approx. ±150 °)
The tilt range is subject to restrictions depending on the cable and lens of camera to be
mounted on pan-tilt head.
Pan range: 300 ° (approx. ±150 °)
Maximum operating speed: 45 °/s
( when the centre of gravity of the units installed on the pan-tilt head has been aligned with
the head's centre of rotation)
(Maximum operating speed with prompter mounted: 15 °/s)
Stop accuracy: ±3 ´
Noise level: Less than NC35 (at less than 30 °/s)
–20 °C to +65 °C
30 % to 90 % (no condensation)
319 M 416 M 168 mm (excluding protrusions)
Approx. 10 kg
AV ivory paint (colour resembling Munsell 7.9Y6.8/0.8)
32 (E)