Panasonic AW-PH405E Handbuch Seite 9

Parts and their function
Rotary head
This rotates in the horizontal direction.
Pedestal
POWER ON/OFF switch
Where a switch is pushed in, the unit's power is turned
on, and the unit's power is turned off after the switch has
jumped out.
AC inlet [AC IN] (AC 3-point inlet)
Connect the accessory AC power cable to this inlet.
Camera mounting base mounting screws
M5 M 22 mm hexagon socket head screws (with flat
washers, spring washers). (3 of each provided as
accessories)
These parts are used to secure the camera mounting
base to the rotary arm.
(See page 11)
Tally lamp (accessory)
This is lit up red by the selected signals.
Rotary arm mounting screws
M5 M 22 mm hexagon socket head screws (with flat
washers, spring washers). (4 of each provided as
accessories)
These parts are used to secure the rotary arm to the
rotary head.
(See page 11)
Rotary arm
This rotates in the vertical direction.
 Camera mounting base
Mount the convertible camera or multi purpose camera
on this base.
 Pan-tilt head mounting holes
These four holes are used when installing the pan-tilt
head. (for hexagon head bolts C4)
 Underneath support plate
In order to prevent the pan-tilt head unit from falling, use
the holes (8.5 mm, one location) in the underneath
support plate to anchor the plate in a different location
from the 4 places where the pan-tilt head is anchored.
 PROMPTER connector
The prompter is connected to this connector.
The maximum current which can be supplied from the DC
12 V OUT socket is 2.5 A.
When the prompter is connected, the pan-tilt head's
speed is reduced to about one-third.
When connecting the prompter, be absolutely sure to
short-circuit the DETECT terminal (Pin No.14) and the
GND terminal (Pin No.15).
p Consult your dealer when a prompter is to
Note
be installed since it will be necessary for
the balance between the mounting fixture
and overall weight and other aspects to be
checked.
Pin layout as seen facing
the prompter connector
Pin No.
1
9
2 PROMPTER VIDEO
10 PROMPTER VIDEO GND
3
11
4
12
5
13
6
14
7
15
8
 Guide pin
Use this to determine the direction in which the camera is
to be mounted.
 Camera mounting screws (U1/4-20UNC)
These are used to secure the camera firmly after it has
been mounted.
 Side blank panel
For normal operation, use the unit with this panel in
position.
8 (E)
Signal Name
– – –
– – –
– – –
– – –
DC 12 V OUT
– – –
GND
– – –
– – –
DETECT
– – –
GND
– – –