Precautions For Installation - Panasonic GP-US932CSAE Handbuch

Precautions for installation

Use this product for indoor use only.
Do not expose this product to direct sunlight for hours and do not install this product near a heater or an air conditioner.
Otherwise, it may cause a drop or malfunction. Keep this product away from water.
Installing place for camera head
If this product is installed on a high place such as a wall and a ceiling, consult your dealer before installation.
• Make sure that the installation area is strong enough to hold the camera, such as a concrete ceiling.
• If an installation area such as plaster board is too weak to support the total weight, the area shall be sufficiently rein-
forced.
Locally procure a tripod, a camera mount bracket, and mounting screws.
A tridpod on which the camera head is mounted, a camera mount bracket, and mounting screws are not provided.
Prepare them according to the material and strength of the area where the product is to be installed.
Prepare them according to the material and strength of the area where this product is to be installed.
• The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength
of the installation area.
• Do not use an impact driver. Use of an impact driver may damage the screws.
• When a screw is tightened, make the screw at a right angle to the surface. After tightening the screws, perform visual
check to ensure tightening is enough and there is no backlash.
Avoid moist or dusty places to install this system
Otherwise, lifetime of the internal parts may be shortened.
Do not expose this product to water or moisture nor operate this product in a humid environment.
Moisture can damage this product and also cause electric shocks.
(In case that this product is exposed to water), turn the power off immediately and contact qualified service personnel for
service.
Avoid installing this product in the following locations:
• Locations where it may get wet from rain or water splash
• Locations where a chemical agent is used such as a swimming pool
• Locations subject to steam and oil smoke such as a kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emissions are produced
• Locations subject to strong magnetic field or radio waves
• Locations where corrosive gas is produced
• Locations where the temperature is not within 0 °C to 40 °C
• Locations subject to vibrations (This product is not designed for on-vehicle use.)
• Locations subject to condensation as the result of severe changes in temperature
Radio interference
When the camera is used near TV/radio antenna, strong electric field or magnetic field (near a motor or a transformer),
images may be distorted and noise sound may be produced.
Be sure to remove this product if it is not in use.
12