Panasonic AW-PH405E Handbuch Seite 13

Installation
(Be sure to ask your dealer to install the unit.)
Mounting the tally lamp
Connect the tally cable connector which is taped to the top of pan-tilt head to the connector of tally lamp.
Mount the tally lamp on the top of the pan-tilt head using the 2 screws provided.
p To ensure that no looseness will develop during use, tighten up the screws with a screwdriver at the torque
Note
specified below.
Mounting the tally lamp Clamping torque
Mounting screws (M3) 0.8 N m (8 kgf cm)
• •
Mount the lamp while paying attention to the wire.
The cable for the tally cable connector is about 50 mm long.
When connecting the cable to the connector, do not pull it out beyond this length.
If the tally lamp is not going to be used, insert the cable which is stuck to the top of the pan-tilt head inside the pan-tilt head,
and attach the blank panel for the tally lamp using the 2 screws provided.
Tally lamp
Tally cable connector
Blank panel
Taped
12 (E)