Trouble Shooting - Parkside PRTA 20-Li A1 Originalbetriebsanleitung

GB MT

Trouble shooting

In the event of an accident or malfunction, remove the battery from the device im-
mediately! Failure to comply may result in injuries from cuts.
Problem Possible cause
Battery (
Appliance
Battery (
won't start
On/Off switch ( 2) defective
Motor defective
Internal loose contact
Intermittent
On/Off switch ( 2) defective
operation
Cutting insert (
Much
vibration
Trimming assembly dirty
Loud noise
Motor defective
Cutting insert (
Trimming assembly dirty
Bad trim
Battery ( 17) not fully charged
64
17) discharged
17) not in
13) broken
13) broken
Corrective action
Recharge battery ( 17)
(Observe the separate operating instructions
for the rechargeable battery and charger)
17)
Insert battery (
(Observe the separate operating instruc-
tions for the rechargeable battery and
charger)
Send in to Service Centre for repair
Send in to Service Centre for repair
Replace cutting insert (
(see „Cleaning and maintenance")
Clean trimming assembly
(see „Cleaning and maintenance")
Send in to Service Centre for repair
Replace cutting insert (
(see „Cleaning and maintenance")
Clean trimming assembly
(see „Cleaning and maintenance")
Recharge battery ( 17)
(Observe the separate operating instructions
for the rechargeable battery and charger)
13)
13)