Removing/Inserting The Battery; Checking The Battery Charge Level; Recharging The Battery; Used Batteries - Parkside PRTA 20-Li A1 Originalbetriebsanleitung

Removing/inserting the
battery
1. To remove the battery from
the device, press the release
button (1) on the battery (4)
and pull the battery out.
2. To insert the battery (4), place it on the
guide track and push it back into the
appliance. It will audibly snap in.
Do not insert the battery until
the appliance is fully assemb-
led. Risk of injury!
Checking the battery charge
level
The battery's (3) charge level is indicated by
the charge state indicator (4).
Press the button for state of charge display
(2) on the battery. The LEDs indicate the bat-
tery's charge level.
3 LEDs are on (red,orange and green):
Battery charged
2 LEDs are on (red and orange):
Battery partially charged
1 LED is on (red):
Battery needs to be charged
Only charge the battery (4) when
the red LED on the charge level indi-
cator is on.

Recharging the battery

Only charge the battery (4) when
the red LED on the charge level indi-
cator (3) is on.
Charging time is approx. 1 hour.
1. Remove the battery (4) from the ap-
pliance, as necessary.
2. Insert the battery (4) in the charg-
ing compartment of the battery
charger (5).
3. Plug the battery charger (5) into a
mains outlet. The red LED on the
control display (6), which is on the
charger, (5) comes on when the
battery (4) is loading. If the green
LED on the charger (5) is on, the
battery (4) is charged.
4. When the battery is fully re-
charged unplug the battery charg-
er (5) from the mains.
5. Pull the battery out of the battery
charger (5).

Used batteries

• If a fully recharged battery lasts for con-
siderably shorter operating times, the
battery is used up and needs to be re-
placed. Only use an OEM battery pack
replacement available from our Customer
Service.
• Always take heed of the applicable safe-
ty instructions as well as the environmen-
tal protection regulations and information
(see "Waste Disposal and Environmental

Protection").

Storage

• Remove the battery before storing the
unit for longer periods of time (e.g. hi-
bernation).
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer stor-
age period (two LED lights of the charge
status display light up).
GB MT
39