Eufab Carlo Plus Montageanleitung Seite 10

Carrier table renewal is already pre-installed
Assembly picture 1
All screws should be treated with oil or grease to ensure they move smoothly in the long-
term. First connect the base to the rack table with the screws; tighten the washers and secur-
ing nuts of the Component D. Ensure that the plate of Component A corresponds to the
boreholes of the rack table. The screws are inserted from the inside to the outside and tight-
ened with the washers and the nuts. Screw in the screw M16 X 130 approx. 1cm into the base
(see photo).
Assembly picture 2
Place the U – bracket onto the designated tube sleeves and secure with 2 lock screws,(M8 x
50) washers (8 mm) and knurled nuts (M8). Insert the pre-assembled lamp holders with the
13-wire plug into the end of the tube of the swivel frame. Ensure that the lamp holder with
the reverse light is on the right (see photo). The lamp holders have two setting options. For
vehicles that are wider than 1740 mm (see section 13 in the car documents), the lamp holders
need to be mounted in the outer position (see photo). For vehicles that are less wide than
1740 mm, the inner hole distance needs to be selected. Align the lamp holder with the 2 des-
ignated knurled screws and insert the screws into the bore-holes (see photo – slightly tighten
the knurled screw). Ensure that the lamps are mounted symmetrically.
Assembly picture 3
Assemble the wheel rails by placing the right wheel rail into a left wheel rail at the long holes.
The right wheel rails have a raised beaded edge on one side of the rail (see photo). Use the
short screws, washers and securing nuts for the inner bore-holes. First loosely screw the
wheel rails to the swivel frame in the central position. (Screw M6 x 20, washer and Nut M6).
Pull out the wheel rails until the outer bore-holes of the swivel frame can be used for attach-
ment purposes. Secure and tighten all screws on the wheel rails. Remove any pre-assembled
screws and washers for the registration plate holder and screw on the registration plate
holder. The lamps and registration plate holder need to be at the same height.
Important information:
The attachment parts for the registration plate holder are enclosed as press-out parts in the
registration plate holder itself. Attach the cable of the lighting unit using the cable tie below
the registration plate holder. Ensure that this cable is not caught or damaged when the cycle
rack is folded up or down.
Press the stoppers onto the wheel rail from the top, 2 on the right and 2 on the left. Ensure
that the higher side of the wedge shape is pointing towards the centre of the carrier. Now
thread the small strap through the middle hole on the stopper and under the wheel rail to the
opposite side, back through the middle hole. You will also need the 2 remaining belts later, in
order to fix the bikes correctly. Open the frame holder clips and place these around the U-bolt
with the insets. Reclose the clips using the finger screw. (Do not yet tighten).
Assembly of the cycle rack onto the towbar
Ensure that the towbar is undamaged, clean and free of grease. The cycle rack is placed on
the towbar from above. Loosely screw the cycle rack with the screw M16 and align parallel to
the rear of the vehicle. Tighten the screw M16 using the supplied key until the rack is attached
securely. Check that the rack is securely on the towbar and that the cycles are firmly in posi-
tion on the rack. Check the function of the cycle rack lighting system regularly.
10