Troubleshooting - Scheppach SD1600V Originalbetriebsanweisung

13. Troubleshooting

Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before
carrying out maintenance work.
Fault
Saw blades break
Motor does not function
Vibration
NOTE: The saw vibrates slightly
when the motor is running in normal
operation.
Saw blade swings out
Holders not aligned straight
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes
Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Mains Gable faulty
Motor faulty
Saw incorrectely installed
Unsuitable underlay
The work bench is not screwed down
or is on the motor
The motor is not secured
Holders not aligned
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt to
repair the motor yourself as this should be
carried out by trained personnel.
Refer to the instructions given earlier in this
manual for information on installing the saw
The heavier the work bench is,the less the
vibration. A bench made from ply wood
always vibrates more than one made from
solid wood. Select the work bench best
suited to your working conditions
Tighten the locking lever
Securely screw the motor in place
Losen the screws with which the holders are
fastenedto the arm. Align the holders so that
they are perpendicular to each other and
retighten the screws.
GB
23 / 48