Machine Positioning - OMCN Gebrauch und wartung Betriebsanleitung

en 28 | GRIP F 20 | Initial commissioning
4.2.6

Machine positioning

1. Put back in place the side door.
2. Loosen the two screws that fix GRIP F 20 to the
pallet.
Warning - damage risk!
The lifting belts can crush the flexible supply
pipes of the cylinder or damage the applied
parts of the GRIP F 20.
€
Insert the lifting belts carefully.
3. Remove the back protection of the locking lever, as
shown.
4. Insert the appropriate lifting belts (length belt 1: 1
Mt, belt 2: 3 Mt), with sufficient capacity, as shown.
2
!
|
1 695 108 479 2016-09-26
1
Warning - tilting danger!
The barycentre of the GRIP F 20 does not lie
in its centre.
€
It is necessary to lift the machine slowly.
5. Lift the GRIP F 20 with a lift crane and install it in
the designed area respecting the minimum distances
as shown in the picture.
For safe and ergonomic use of the GRIP F 20 it is rec-
ommended to leave a minimum of 500 mm space from
the surrounding walls.
Warning - tilting danger!
During tire inflation considerable forces are
exerted.
€
The GRIP F 20 has to be fixed in at least 3
points on the floor (screw holes see chap.
4.2)..
i
In each screw hole are placed shock absorbers, to
allow a vibration free installation .
6. Put an appropriate lubricator in the mounting paste
holding device.
OMCN spa