Troubleshooting - Abicor Binzel FEC W3 Betriebsanleitung

FEC W3

10 Troubleshooting

DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the device. The
product warranty will be rendered invalid if work is carried out on the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
CAUTION
• Suitable safety measures must be taken before performing maintenance and cleaning work.
• Maintenance and cleaning work must only be carried out on the extraction system in areas with locally filtered forced
ventilation.
• Check and wear your personal protective equipment.
• Personal protective equipment consists of protective clothing, safety goggles, a class P3 respiratory mask, protective
gloves and safety shoes.
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems, please contact your retailer
or the manufacturer.
Fault
Unit is not ready for operation
Dust emission during dedusting
Error message for 0/Error LED:
8 short flashes
Error message for 0/Error LED:
3 short, 1 long, 4 short flashes
Tab. 10 Troubleshooting
BAL.0675.0 • 2019-09-16
Cause
• Device component defective • Have it checked and replaced by qualified
• Extraction system defective
• Carbon brushes defective
• Fume extraction system
cannot be switched on
• Reduced extraction capacity
• Exhaust air filter dirty
• Motor runtime > 8 hours
• Excess temperature > 60°C • Switch off the device, allow to cool
10 Troubleshooting
Troubleshooting
personnel
• Have it checked and replaced by qualified
personnel
• Have it checked and replaced by qualified
personnel
• Switch off the power to the system
Check motor protective switch (by professional)
• Clean the filter/empty the filter housing
 9.2 Filter dedusting on page EN-20
 9.3 Emptying the filter housing on page EN-22
• Switch unit to currentless state, replace the filter
 9.4 Changing the filter on page EN-23
• Check suction hose for cross-section reduction and
replace as needed
• Check suction hose for damage and clogging and
replace as needed
• Replace exhaust air filter
 9.4.3 Replacing the exhaust air filter on
page EN-25
• Switch off the device
EN - 27