Troubleshooting - Abicor Binzel FES-200 W3 Betriebsanleitung

10 Troubleshooting

10 Troubleshooting
Risk of injury and machine damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the
device. The product warranty will be rendered invalid if work is carried out on it by unauthorised
persons.
• Operating, maintenance, cleaning, fault and repair work may only be carried out by qualified
• Before performing any maintenance and cleaning work, suitable safety measures must be taken.
• Maintenance and cleaning work on the fume extraction system may only be carried out in areas with
• Always wear your personal protective equipment when performing maintenance and cleaning work.
• The personal protective equipment includes protective clothing, safety goggles, respirator mask
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems, please
contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source,
Fault
Fume extraction system is not ready
for operation
Suction too weak,
manometer indicator is near the red
point
Despite dedusting of the filter:
manometer indicator remains near
the red mark
Tab. 8 Troubleshooting
EN - 24
DANGER
personnel (in Germany see TRBS 1203).
CAUTION
locally filtered forced ventilation.
Class P3, protective gloves and safety shoes.
welding torch system, re-circulating cooling unit etc.
Cause
• Control system or component defective • Check and replace if necessary
• Turbine defective
• Carbon brushes defective
• System cannot be switched on
• Suction hose clogged
• Filter cartridge soiled
• Filter pores are clogged
Troubleshooting
• Check and replace if necessary
• Check and replace if necessary
• Switch off the power to the system
Check voltage circuit breaker and replace if
necessary
• Check the straightness of the suction hose and
change it if necessary
• Check suction hose for damage and clogging
• Hold the hose vertically and use a rubber
hammer to clean it
• Dedust the filter
 5.2 Filter dedusting (dedusting by rotation) on
page EN-14
• Replace the filter cartridge
 5.3 Replace the filter cartridge on page EN-16
FES-200 W3