Troubleshooting; Disposal; Packaging - Abicor Binzel FES-200 Betriebsanleitung

FES-200

10 Troubleshooting

NOTE
• If the measures described below are not successful, please consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding components, such as the power source,
Fault Cause
Unit is not • Control or component defective
ready for
• Turbine defective
operation
• Carbon brushes defective
• System cannot be switched on
• Reduced extraction capacity
Troubleshooting
Tab. 7

11 Disposal

For disposal, observe the local regulations, laws, provisions, standards and guidelines.
11.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.
11.2 Consumables
Oil, grease and cleaning agents must not contaminate the ground or enter sewage systems. These materials
must be stored, transported and disposed of in suitable containers. Observe the relevant local regulations
and disposal instructions of the safety data sheets specified by the manufacturer of the consumables.
Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with the
information provided by the manufacturer of the consumables.
The disposal of dust collecting bags is subject to special waste regulations. The dust must not enter sewage
systems or be disposed of together with normal household waste. Please observe the local and official
regulations.

11.3 Packaging

ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
welding torch system, re-circulating cooling unit, etc.
Solution
• Have it checked and replaced by qualified personnel
• Have it checked and replaced by qualified personnel
• Have it checked and replaced by qualified personnel
• Switch unit to currentless state
Check the 0.5 A fuse and replace it, if necessary.
• Clean the filter
• Switch unit to currentless state
Replace the filter
• Check the straightness of the extraction hose and change it
if necessary
• Check suction hose for damage and clogging
• Cleaning the dust collecting drawer
10 Troubleshooting
EN - 15