Risks In Handling Exhaust Hoods - hanseatic SY-103E9A-P1-C84-L121-600 Gebrauchsanleitung

Mains cord / mains plug
■
– Take care to prevent the risk of tripping
when laying the mains cord.
– Do not kink or pinch the mains cord or
lay it over sharp edges.
– Do not extend or modify the mains cord.
– Keep the mains plug and cord away from
naked flames and hot surfaces.
– If the mains cord of the appliance is
damaged, it must be replaced by the
manufacturer, through customer service
or by a qualified specialist.
Independent or improper repairs made
■
to the appliance may cause damage to
property and personal injury; any liability
and warranty claims will be forfeited. Nev-
er try to repair a defective or suspected
defective appliance yourself.
In the event of a fault or before extensive
■
cleaning, remove the mains plug from the
socket or switch off /remove the fuse.
Do not put any objects in or through the
■
housing openings and also make sure
that children cannot insert any objects
through them.
Fire hazard!
Do not operate the appliance with an ex-
■
ternal timer or an external remote control
system.
Risks for certain groups of people
WARNING
Risk of suffocation!
Do not allow children to play with the
■
packaging fi lm. They may get caught in it
or suff ocate.
Prevent children from pulling small parts
■
from the device or taking them out of the
accessory bag and putting them in their
mouths.
For your safety
CAUTION
Dangers for children and people with limited
physical, sensory or mental capacity!
This appliance can be used by children
■
aged eight years and above and by per-
sons with reduced physical, sensory or
mental abilities, or who lack experience
and/or knowledge, if they are supervised
or have been instructed in the safe use
and understand the dangers associated
with its use.
Cleaning and maintenance must not be
■
carried out by children unless they are su-
pervised.
Children should not be allowed to play
■
with the appliance nor should they have
access to the appliance when left unat-
tended.

Risks in handling exhaust hoods

WARNING
Risk of electric shock!
Before drilling the holes to mount the ap-
■
pliance on the wall, ensure that no wires
or cables (power, gas, water etc.) will be
damaged (check with a line locator).
If a glass cover is broken, the exhaust
■
hood must not be used until the glass cov-
er has been replaced. If this is the case,
contact our customer service (see page
EN-21).
Page EN-5