Wires Connection; Rt2X - Rt2 With Module For Wireless Control Tx - Oeg Rt2R Bedienungsanleitung

Wires connection

WARNING: Mounting and wiring connections must be done by a
qualified installer or authorized company. Local regulations or VDE
0100 and EN IEC 60364 regulations for electrical installations must
be considered by doing the wiring connections.
Bring the wires through the opening in bottom of the wall plate
(Picture 30-position A). How to connect module is detailed
described on pages 152 to 158.
RT2 enables connection of following modules:
- relay module (R)
- module for wireless control (TX)
RT2 also enables connection of the:
- auxiliary temperature sensor
- device for remote control with telephone
RT2X - RT2
with module for wireless control TX
RT2X enables wireless control for 9 different heating systems
(see Table 2 on page 32). The receiver should be mounted in the
near of controlled device.
Thermostat and receiver must have the same radio channel Nr.
(setting P2.8, page 27).
Set the controlled heating system in service group S1.1 (page 28)
(default factory setting is 1).
For connecting the ET2X see Receiver manual.
35
Installation manual