Radio Connection - Test Mode For Rt2X - OEG RT2R Bedienungsanleitung

Service group S3
Service group S3 is intended for special thermostat's settings.
In program group S3 are the following parameters:
- [S3.1] Group locking (- - - no locking,
Access to parameter S3.1 is possible in the following way. Hold key
i i i i
for 20 seconds (picture 24). Release the key after you hear a beep. On the
display appears parameter (S3.1). Now it's possible to modify this or any
other parameter.
1
Parameters S2.8, S2.9 and S2.10 are intended only for heating
circuit with 3 point control.
Picture 24

Radio connection - test mode for RT2X

Check if your receiver has the same radio channel number as set-
ted in parameter S2.8 on RT2X. Now activate test mode. Hold key
and pres and hold key
Release the keys after you hear a beep.
Settings manual
1 - locked are groups S,
2 - locked are groups S and P,
3 - locked complete menu); (1)
30
for 5 seconds (picture 25).