Maintenance Instruction - Heyner MultiRelax AERO Fix Bedienungsanleitung

English
Attention: The belt should not be twisted. To ensure
an optimum belt run, the headrest should be adjusted
correctly to the child.
In order to adjust the height of the headrest (A) to the
size of the child, grasp the headrest from in front and
pull the adjustment lever (H) up.
Now you can adjust the headrest (A) to the desired
height. The distance between the lower edge of the
headrest and the shoulder of the child should be two
fi nger's width. As soon as you have reached the correct
height, release the adjustment lever (H) and the head-
rest (A) locks into place at the desired height.
Now guide the lap belt (W) including the buckle tongue
(V) over the armrests of the child car seat to the three-
point belt buckle and snap the belt buckle (V) of the
three-point belt of the vehicle in the three-point belt
buckle until a <<click>> sound is clearly heard.
IMPORTANT:
The diagonal belt should run centrally across the shoul-
der and the lap belt should run as low as possible
across the goin.
Make sure that the diagonal belt runs exactly and that
it is not too close to the body of the child. All the belts
must lie fi rmly against the child's body and must not be
twisted.
33
A fl at hand should fi t snugly between the belts and the
body of the child. Adjust belt height adjusters, in case
you have them in your car, to the size of the child and to
the size of the seat. Check the run of the belts and the
height of the support for the head from time to time and
adjust them to the growing child.
Please strictly follow the drawings and the installation
instructions.
Should you have any questions, please contact your
dealer, the importer or the manufacturer.

3. Maintenance instruction

Loosen the shoulder belts by pressing the belt adjusters
(GV) and pull the harness belts (G2) towards you.
Do not tear at the shoulder pads.
Loosen the belt ends of the harness belts (G2) on the
back side of the seat part (ST) from the belt anchor (R).
English
GB
Press
34