YUNEEC Typhoon H Bedienungsanleitung Seite 13

2
If the pilot set 7 waypoints as shown, when the copter arrives at the Waypoint 1,
slowly raise the throttle stick, the copter will fly along the waypoints from 1 to 7 in
order. If the pilot slowly lower the throttle stick, the copter will fly along the
waypoints from 7 to 1 in order.
NOTICE: Adjust the Throttle Control joystick to change the height of the aircraft,
adjust the Aileron Control joystick to change the orbit direction of the aircraft.
JOUR: Journey function enables Typhoon H to capture the perfect aerial selfie
or any scenic much easier. Depending on the pilot's desired setting, Typhoon
H will go up, out and return.
Tap JOUR to enter the journey function.
START: Select JOUR and set the distance, then slide the slider.. Typhoon H will fly up and
out and then take a photo.
BACK: Tap BACK to return to the previous interface.
After sliding the icon, the remote control interface will display EXIT and [
the pilot tap the [ ]， the icon will become [
paused. When the pilot taps it again, the [
continue the journey function. The pilot can exit the function by tapping EXIT icon
or switching flight mode.
NOTICE: When the Journey function is activated, the Journey distance can be set
by the pilot.
NOTICE: The gimbal camera can't be controlled when journey function is
activated and will remain the previous angle set before. Depending on the camera
tilt, the aircraft will go up and out to take the perfect selfie.
NOTICE: The journey route is the reverse direction to which the gimbal camera
facing towards.
4
3
5
6
7
1
2
1/3
]. Then the journey function is
] will become [ ], the copter will
ORBIT ME: When Orbit Me is enabled, Typhoon H flies a circular path around the pilot.
Press ORBIT to enter the ORBIT ME function.
START: Press START, and slide the icon, push the aileron stick to the right or left, then Typhoon H
will fly around the pilot with the distance between the start point and the pilot as the radius.
BACK: Tap BACK to return to the previous interface.
[ ]: When the pilot tap the [
paused. When tap it again, the [
function. The pilot can exit the function by tapping EXIT icon or switching flight mode.
NOTICE: You can increase/decrease radius by apply forward/back on right stick.
You also can trim the gimbal pan position by adjusting pan control knob on ST16.
NOTICE: The tilt direction of gimbal camera can be adjusted by the camera tilt control knob.
NOTICE: If the aircraft flies too close to the pilot, it will automatically enlarge the distance and then
begin to orbit.
NOTICE: Adjust the Throttle Control joystick to change the height of the aircraft, adjust the Aileron
Control joystick to change the orbit direction of the aircraft.
POI: Point of Interest allows the pilot to select a subject they would like to orbit and have
Typhoon H orbit that subject autonomously.
CENTER: Press CENTER to set the current flight position of Typhoon H as the center of a circle.
START: Press START, and slide the icon, push the aileron stick to the right or left, Typhoon H will fly
around the circle center with distance between the Start point and the center point as the radius.
BACK: Tap BACK to return to the previous interface.
NOTICE: You can increase/decrease radius by apply forward/back on right stick.
You also can trim the gimbal pan position by adjusting pan control knob on ST16 (The pilot can
refer to ORBIT for camera tilt trimming).
NOTICE: Adjust the Throttle Control joystick to change the height of the aircraft, adjust the Aileron
Control joystick to change the orbit direction of the aircraft.
[ ] When the pilot tap the [
When tap it again, the [
]. When
can exit the function by tapping EXIT icon or switching flight mode.
12
]， the icon will become [ ]and the ORBIT ME function will be
] will become [ ], the copter will continue the ORBIT ME
]， the icon will become [ ]and the POI function will be paused.
] will become [ ], the copter will continue the POI function. The pilot