Displaying Elapsed Operating Hours - Dometic FRIGO Bedienungsanleitung

Operation
Deleting the measured temperatures
➤ Press the
button or the
✓ On the display, "Hi" or "Lo" is briefly displayed, followed by the measured and
stored temperature.
➤ Hold down the
✓ "rSt" flashes on the display.
✓ The current loading area temperature is shown on the display.
5.8

Displaying elapsed operating hours

➤ Press the
button.
✓ The display shows the ten thousand operating hours that have already elapsed.
The number of operating hours is made up of the top line (steps of ten thousand)
and the bottom line (steps of one).
SET
I
NOTE
If "SEr" appears on the display, maintenance must be performed. Initial
maintenance should be carried out 100 operating hours after start-up.
All other maintenance should be carried out after every 1000 hours of
operation.
During maintenance, the operating hours are reset.
18
button.
SET
button for longer than 3 seconds.
Figure 11: Displaying the elapsed operating hours
Frigo
EN