Equipment Specifications - Parkside PTB-16 Bedienungs- Und Sicherheitshinweise

Equipment specifications

PILLAR DRILL
The numbers in the following text
correspond to the numbers in the
illustrations.
Warning! Always read the
instructions for electrical products
carefully before use. This enables
you to become more familiar with
the product and avoid
unnecessary risks. Keep these
instructions in a safe place, where
they are always available.
1. EQUIPMENT
SPECIFICATIONS
Technical specifications
Rated voltage
Rated frequency
Rated input
Operation mode
Motor speed without load 385-2600/min
Number of speeds
Capacity drill chuck /
Spindle Nose Taper
Max. drilling depth
Max. drilling capacity steel 16 mm
Weight
L (Sound pressure level) 58 dB(A)
pA
L (Sound-power level)
WA
Vibration
The operation mode S2 30 min means
that you must allow the drill to cool down
to room temperature after 30 minutes of
continuous use.
30 GB/MT
Drill overview
Fig. A, B, C
1. Motor
2. Locking screws
3. Feed handle
4. Clamp lever
5. Baseplate
6. Column
7. Drilling table
8. Screw clamp
9. Chuck guard
10. Drilling depth display
11. On/Off switch
12. V-belt housing
13. V-belt pulley
14. Motor plate
15. Centring
16. Hexagonal screw
17. Adjusting screw
18. Fitting for chuck key
19. Ring
230 V
20. Wing nuts
50 Hz
21. Vice screws
500 W
S2 30 min
Scope of supply
1 Pillar drill
9
1 Drill chuck
1 toothed ring key
16 mm/MT-2
2 Allen key
50 mm
3. Feed handle
3 Screws M8
20.5 kg
3 Washers M8
1 Machine vice
71 dB(A)
2 Screws M10
1.34 m/s
2
4 Washers M10
2 Nuts M10
Before starting up please check whether
the supply is complete and/or has been
damaged during transport.
Your pillar drill has only been designed for
drilling metallic materials.
This device is intended exclusively for use