Introduction; Proper Use; Features And Equipment; Included Items - Parkside PHLG 600 Bedienungs- Und Sicherheitshinweise

Introduction

The following icons / symbols are used in this instruction manual:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock! Dangerous
electric current – danger to life!
Risk of fire!
Risk of explosion!
Do not expose the appliance to rain or
moisture. The permeation of liquids into
electrical appliances increases the risk
of receiving an electric shock.
V ~
Voltage
Hot air gun PHLG 600
For removing, reshaping, preheating,
defrosting etc.
Introduction
Q
Please make sure you familiarise your-
self fully with the way the device works
before you use it for the first time and
that you understand how to handle electrical pow-
er tools correctly. Further details can be found in
the operating instructions. Keep these instructions in
a safe place. If you pass the device on to anyone
else, please ensure that you also pass on all the
documentation.
6 GB/IE/CY
W
Watt (performance)
Wear hearing protection, dust
protection mask, protective glasses
and protective gloves.
Protection category II power tool;
double insulated
Proper procedure and handling.
Keep children and uninvolved other
third parties at a distance when using
electrical power tools.
Damaged appliances, power cables
and power plugs mean potentially fa-
tal risks from electric shock. Regularly
check the condition of the appliance,
the power cable and the power plug.
Dispose of packaging materials and
the appliance in an environmentally
responsible manner!

Proper use

Q
The hot air gun is intended for the removal of paint,
for warming (e.g. heat-shrinkable sleeves) and for
reshaping and welding of plastics. It may also be
used for detaching glued connections and for de-
frosting or thawing water pipes. Any other use or
modification to the device shall be considered as
improper use and could give rise to considerable
dangers. The manufacturer will not accept liability
for loss or damage arising from improper use. The
device is not intended for commercial use.

Features and equipment

Q
Air inlet
1
2 ON / OFF switch & temperature and
air volume regulator
3 Heat shield
Nozzle
4
Reflector nozzle
5
6 Protector nozzle
Flat nozzle
7
8 Reducer nozzle

Included items

Q
Immediately after unpacking the appliance, check
that all listed items have been supplied.
1 Hot air gun PHLG 600
1 Reflector nozzle
1 Protector nozzle
1 Flat nozzle
1 Reducer nozzle
1 Operating instructions
1 Guarantee documentation

Technical information

Q
Nominal voltage: 230 V ~ 50 Hz
Power consumption: max. 2000 W
Air volumes: Setting I: ca. 250 l / min.
Setting II: ca. 350 l / min.
Setting III: ca. 600 l / min.
Temperatures
(Jet outlet nozzle): Setting I: ca. 30 °C
Setting II: ca. 400 °C
Setting III: ca. 600 °C
Overload protection: Temperature cut-off switch
II / &
Protection class:
The sound pressure level (A) of the device is typically
less than 70 dB (A).
Overheating cut-out:
Upon heater overload (e.g. due to air-flow blockage)
the appliance automatically switches the heater off,
though the fan continues to run.
Introduction / General safety advice
PHLG 600
KH 3166
Date of manufacture: 02-2008
230 V ~ 50 Hz · 2000 W
Kompernaß GmbH · 44867 Bochum (Germany)
www.kompernass.com

General safety advice

J
ATTenTIOn! Please read all the instructions
and advice. Failure to observe the instructions
and advice given below may result in electric
shock, fire and / or serious injury.
MAKE SURE THAT YOU KEEP THESE INSTRUC-
TIONS AND SAFETY ADVICE IN A SAFE PLACE.

1. Your working area

a) Keep your working area clean and
clutter-free. Untidy or poorly lit working
areas can lead to accidents.
Do not work with the device
b)
in potentially explosive envi-
ronments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other people
away while you are operating
the electrical tool. Distractions can
cause you to lose control of the device.

2. electrical safety

a) The mains plug on the device must match
the mains socket. The plug must not be
modified in any way. Do not use an
adapter plug with devices fitted with a
protective earth. Unmodified plugs and
matching sockets reduce the risk of electric shock.
GB/IE/CY 7