Fitting / Using The Dust Extraction Device; First Use; Switching On And Off; Pre - Selecting The Rotational Speed - Parkside PSB 1050 A1 Originalbetriebsanleitung

Assembly tools for screws and nuts:
j
When using screwdriver bits, always use a
universal bit holder.
j
To screw things in, always switch the changeover
switch "drill / percussion drill"
position .
Fitting / using the dust
Q
extraction device
j
Only use the dust extraction device when work-
ing on cement, brick and building stone. Wood
or plastic shavings could easily lead to the de-
vice becoming blocked.
ATTENTION! FIRE HAZARD! Do not work
on any metal materials when you have fitted
the dust extraction device. Hot metal filings could
set parts of the dust extraction device on fire.
NOTE: The dust extraction device
fitted to the additional handle
has previously been removed. If need be, loosen
the wing screw by turning it anti - clockwise and
9
remove the depth stop
you have fitted the dust extraction device
tighten the wing screw
j
Loosen the sing screw
extraction device
11
tional handle .
10
j
Tighten the wing screw
wise.
j
You should preferably use a workshop vacuum
cleaner for dust extraction purposes. Connect
the tube of the dust extraction device with the
angle adapter ; see also Figure F.
12
NOTE: We recommend the use of a dust ex-
traction device up to a drill size of 13 mm.
11
j
If it is necessary to use the reducer piece
push the reducer piece into the adapter for ex-
ternal vacuum extraction
j
To dismantle, proceed in reverse order to what
is described above.
to the right to
2
can only be
11
if the depth stop
10
. Attach it again after
8
and
11
again.
9
and place the dust
9
precisely onto the addi-
by turning it clock-
9
13
.
12

First use

Q

Switching on and off

Q
When operating the hammer - action drill you can
select between intermittent or continuous operation
mode.
To switch on intermittent operation mode:
j
Press the ON / OFF switch
To switch off intermittent operation mode:
j
Release the ON / OFF switch
Switching continuous operation on:
j
Press and hold the ON / OFF switch
and press the locking button
To switch off continuous operation mode:
j
Press and then release the ON / OFF switch
8
Pre - selecting the
Q
rotational speed
With the handwheel for speed preselection
you can pre - select the rotational speed in steps.
j
The rotational speed that is suitable depends
on the material that has to be processed. We
recommend you carry out tests first to deter-
mine the best rotational speed.
Tip: These two basic rules with regard to rota-
tional speed will, however, always help you:
1. large drill diameter = lower rotational speed
and so a smaller drill diameter = higher rota-
tional speed
2. harder material = lower rotational speed
Infinitely variable adjustment
Q
,
of the rotational speed
The ON / OFF switch
control device. Slight pressure on the ON / OFF
switch will bring about a low rotational speed.
4
The rotational speed will increase the more pres-
sure you exert.
Before first use / First use
.
4
.
4
4
.
3
has a variable speed
4
down
.
4
,
5
GB/IE 11