Included Items; Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PSB 1050 A1 Originalbetriebsanleitung

Included items

Q
1 2 - Speed hammer drill PSB 1050 A1
1 Auxiliary handle
1 Dust extraction device
1 Angle adaptor
1 Reducer piece
1 Depth stop
1 Carry case
1 Operating instructions

Technical data

Q
Nom. voltage:
Rated power:
No - load
rotational speed:
Chuck capacity:
Recommended areas of operations
Drilling in steel:
Drilling in wood:
Percussion drilling
into cement:
Screwing:
Protection class:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A - weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level: 109.5 dB(A)
Uncertainty K:
Wear ear protection!
Impact drilling in concrete:
max. Vibration emission value
a = 14.826 m / s
2
h, ID
Uncertainty
K = 1.5 m / s
2
Introduction / General safety advice for electrical power tools
230 V ~ 50 Hz
1050 W
1st gear 0 - 1450 min
-1
2nd gear 0 - 3400 min
-1
max. 13 mm
max. ø 13 mm
max. ø 40 mm
max. ø 16 mm
max. ø 8 mm
98.5 dB(A)
3 dB
Drilling in metal:
max. Vibration emission value
a = 3.745 m / s
2
h, D
Uncertainty
K = 1.5 m / s
2
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool
is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
ly in use. This can result in a much lower vibration
load over the whole of the period of working.
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electrici-
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
GB/IE 7