Care And Maintenance - Clas Ohlson iWood 7 Mini BT Bedienungsanleitung

8. Bluetooth
Please read the instruction manual of the device you wish to connect before beginning.
By remote control
1. Press [BT] to activate Bluetooth.
2. Hold down [BT] until the speaker switches to scan mode (scans for available
Bluetooth devices). The Bluetooth indicator
show in the display.
Note: If you are asked for a PIN code, you should enter 0000 (four noughts).
Certain devices even require you to approve the connection.
3. When the Bluetooth indicator
have been successful. You should now be able to hear the audio through
the speaker from the connected device.
Using the front panel
1. Press [IN] until "BT" is shown to activate Bluetooth.
2. Press [IN] and [SET] simultaneously until the speaker switches to scan mode
(scans for available Bluetooth devices). The Bluetooth indicator
"SCAN" will be displayed.
Note: If you are asked for a PIN code, you should enter 0000 (four noughts).
Certain devices even require you to approve the connection.
3. When the Bluetooth indicator
will have been successful. You should now be able to hear the audio through
the speaker from the connected device.
9. Radio
1. Select FM or AM by pressing [TUNER] on the remote, or [IN] on the front panel.
Make sure that the aerial is connected to the back panel of the speaker.
2. Station selection.
• Manual search: Press [ ] and [ ] on the remote to search for a station.
• Automatic search: Hold down [ ] or [ ] for about three seconds to start an
automatic station search.
3. Saving radio station presets with the remote control.
• Press [MEM] until "CH00" is displayed. Select a preset slot to save the station by
using [ ] or [ ]. Press [ENTER] to confirm. Up to 30 presets can be saved.
• Press [MEM] for about three seconds to enter auto search and save mode.
4. Use [CH-] and [CH+] to select desired radio presets.

10. Care and maintenance

Unplug the lead before cleaning. Use a soft moist cloth to clean the product.
Use a mild detergent and never use solvents or strong, abrasive cleaning agents for
cleaning the product.
will quickly flash and "SCAN" will
reverts to a steady and slow flash, connection will
reverts to a steady and slow flash, connection
9
will flash and