Care And Maintenance - Clas Ohlson NE-8302-UK Bedienungsanleitung

Connecting a device using NFC (Near Field Communication)
Note: NFC can be used to connect to the speaker in standby-, Bluetooth-mode or
when AUX mode is activated. Any previously selected function will automatically be
deactivated while the device is connected via NFC.
1. Activate NFC on the device to be connected to the speaker.
2. Place the part of your device where the NFC antenna is situated (refer to your
device's instruction manual if you are unsure) against the speaker's NFC detection
zone (4). Information on how to connect the speaker will appear on your device.
Follow these instructions to connect.
3. The speaker will emit an audio signal and the Bluetooth LED will shine a solid blue
once the speaker has been successfully connected.
Using the line-in jack for playback
1. Press [ MODE ] either on the speaker or the remote until the LED indicator shows
that AUX is selected.
2. Connect the device to the 3.5 mm line-in jack (12) on the speaker's back panel.
3. Lower the volume and start playback on the device.
4. Adjust the volume both on the device and the speaker to the desired level.
Note: It is not possible to control playback from the Bluetooth speaker or remote
when a device is connected via the line-in jack. Playback must then be controlled from
the connected device.

Care and maintenance

• Disconnect the plug from the wall socket and remove the battery from the remote
control if the speaker is not to be used for a long time.
• Clean the speaker using a lightly moistened cloth. Use only mild cleaning agents,
never solvents or corrosive chemicals.
6