Time Display - Clas Ohlson iWood 7 Mini BT Bedienungsanleitung

Alarm
1. Press [ALARM S] twice on the remote. "ALM" will begin flashing.
Press [ENTER] to confirm.
2. Toggle to ON using [
3. The hour display will begin to flash. Set the hours using [
Note: The clock only has a 24-hour display format. Press [ENTER] to confirm.
4. The minutes display will begin to flash. Set the minutes using [
Press [ENTER] to confirm.
5. Once the alarm time has been set, you can set the type of alarm. Toggle between
the various setting using [
iPod/iPad/iPhone → BUZZ etc. Press [ENTER] to confirm.
6. Turning off the alarm:
• Press [ ] on the remote to turn off the alarm directly.
• Press any button on the front panel or remote twice to turn off the alarm.
• Press [ ] once after the alarm has been turned off to turn on the speaker.
Snooze
Press any button on the front panel or remote aside from [ ] to snooze.
The alarm will sound again after nine minutes.
Alarm deactivation
Follow steps 1 and 2 and then press [

Time display

Press [DISP MODE] to turn the time display on or off while in standby mode.
7. iPod/iPhone/iPad connection
1. Use the settings dial to select
the correct device. Then connect your
iPod/iPhone/iPad device. Make sure
that the speaker is correctly set by
pressing [iPod] on the remote.
2. Selecting a video output (only valid for
iPod/iPhone/iPad). If you are playing
video from your iPod/iPhone/iPad, hold
down [iPod] on the remote for about
three seconds.
3. iPod/iPhone/iPad controls.
The controls on the remote work just like the click-wheel on your iPod
(refer to your iPod manual for further detail).
] and [ ]. Press [ENTER] to confirm.
] and [ ]. BUZZ (buzzer) → TUNER (radio) →
] on the remote to turn off the alarm.
8
] and [ ].
] and [ ].