Care And Maintenance - Clas Ohlson iDeco Stereo 100BT Bedienungsanleitung

Via AUX IN
1. Connect an appropriate cable (sold separately) from the device to the speaker's
AUX IN (RCA) port.
2. Turn on the speaker system and press [INPUT] on the control panel or the remote
until "AU" (AUX-IN mode) is shown in the display.
3. Lower the volume on the connected device and start playback.
4. Adjust the volume to a desired level.
Video Playback via VIDEO OUT
1. Connect the appropriate cable, composite or S video (sold separately), to
the speaker's VIDEO OUT socket and the other end to your TV.
2. Carefully insert your iPod/iPhone/iPad into the dock.
3. Turn on the speaker system and press [SETUP] on the remote until "TV"
(VIDEO OUT mode) is shown in the display. Note: The "TV" symbol will only flash
by shortly indicating (VIDEO OUT mode) is active. The display will show the pre-
vious setting even though the "TV" (VIDEO OUT mode) is activated.
4. Make sure your TV is in the correct mode to receive the signal from the cable
that is connected to it. Read your TV's instruction manual if you are unsure.
5. Start playback on your iPod/iPhone/iPad.
6. Control playback as described in the Buttons and functions section above.
Note:
• Depending on the model of iPod/iPhone/iPad you use, you may need to press
[SETUP] on the remote to switch between viewing video on your docked iPod/
iPhone/iPad or on the connected TV.
• Depending on your model of iPod/iPhone/iPad, you may need to press
the play-symbol on your iPod/iPhone/iPad in order to start playback.
• The buttons on the remote work differently depending on what model of iPod,
iPhone or iPad you use.

Care and maintenance

• Clean the speakers using a lightly moistened cloth. Only use mild cleaning agents,
never solvents or corrosive chemicals.
• Unplug the mains lead from the wall socket during thunderstorms.
• Store the speakers in a dry and dust-free area when you are not using the speakers
for a longer time period.
8