Operation - Clas Ohlson iWood 7 Mini BT Bedienungsanleitung

5. Assembly
The speakers can be used with or without the foot.
Use without the foot
Rubber feet are pre-mounted onto the speaker to protect underlying surfaces if you
choose not to use the foot.
1. Place the speaker on an even and stable surface and ensure that the surface can
support the speaker's weight.
2. Make sure that the speaker is secure and cannot fall or be jarred from its position.
Use with foot
1. Line up the foot's base with the pre-drilled
screw holes in the base and secure the base
to the foot using the included screws.
Note: Do not use a mechanised screwdriver. Use
a manual screwdriver and do not over-tighten.
2. Line up the foot's base with the pre-drilled
screw holes in the base and secure the base to
the foot using the included screws.
Note: Do not use a mechanised screwdriver. Use
a manual screwdriver and do not over-tighten.
3. Fit the foot's base between the speaker's
rubber feet and secure the base with the inclu-
ded screw. Note: Do not use a mechanised
screwdriver. Use a manual screwdriver and do
not over-tighten.

6. Operation

Start
1. Turn on the speaker using the power switch. The speaker will come on in
standby mode and show a time display.
2. Press [ ] on the remote.
3. The buttons and display will illuminate and the last used audio/video source
will be displayed.
Standby
Press [ ] on the remote.
Or alternatively:
Press [VOL+] and [VOL-] simultaneously.
6