Installation - LIVARNO LUX HG03167D Montage-, Bedienungs- Und Sicherheitshinweise

Before installation ensure that the circuit, to which the product will be connected,
is not energised. To do so, remove the fuse or switch off the circuit breaker in
the fuse box (0 position).
Use the voltage tester to verify the de-energised status.
The included mounting material is suitable for ordinary solid concrete or masonry
construction. Check which mounting material is suitable for your chosen mount-
ing surface. If necessary, seek expert advice.

Installation

Make sure you will not be drilling into electrical, gas or water lines inside the wall.
Use a power drill to drill the holes into the brick wall. Always observe all safety in-
structions for the power drill in the manual for the power drill. Death or injury due
to electric shock may otherwise result.
When selecting the mounting location, pay attention to the following:
Make sure that the product illuminates the desired area.
Make sure the motion sensor
has a maximum coverage range of 8 m, with a coverage angle of about 90 °
(depending on the mounting height – a height of 1.8–2.5 m is ideal) (see fig. J).
Make sure the motion sensor
This can influence its functioning.
Remove the lamp shade
Remove the nuts
the silicon washers
terminal block
12
Use the holes in the connection housing
ing screws , to mark the drill holes. Ensure that you fasten the connection
11
housing with the arrow facing upwards inside the connection housing
Now drill the fixing holes (Dia. approx. 6 mm, depth approx. 40 mm). Ensure
that you do not damage the electrical supply line.
Now place the wall plugs
Slide the mains connection lead
Fasten the connection housing with the mounting screws
(see fig. E).
Connect the connection cable of the product to the mains connection lead
by means of the terminal block
Also ensure that the colour connection of the wires is correct when connecting
(L = black or brown, N = blue or white).
covers the desired area. The motion sensor
16
is not illuminated at night by street lighting.
16
from the lamp body
1
visible at the front of the wall plate
5
, and open the connection housing
3
from the connection housing
into the drill holes.
10
through the cable entry with the membrane
13
(see fig. F).
12
.
2
, flat washers
6
7
for easy installation (see fig. B).
7
, which are intended for the mount-
7
which are included
11
16
and
4
. Then take out the
.
7
.
8
13
GB/CY 9