Replacing A Led Bulb; Adjusting The Motion Sensor - LIVARNO LUX HG03167D Montage-, Bedienungs- Und Sicherheitshinweise

Now connect the earth wire (green-yellow) to the marked earth terminal
(see fig. F).
Ensure the seal ring
attached the wall plate
connection housing
secure with the two nuts
Check for correct fitting.
Open the lamp shade
body with the crosshead screwdriver (see fig. G). Insert the LED bulb
2
into the socket carefully with a cloth and tighten it with a ¼ turn in a clockwise
direction.
Place the lamp shade
locking screws
Reinsert the fuse or switch the circuit breaker back on. Your product is now ready
to use.

Replacing a LED bulb

CAUTION! RISK OF ELECTRIC SHOCK!
To replace the LED bulb
circuit. To do this, remove the fuse or switch off the circuit breaker in the fuse
box (0 setting).
Allow the product to cool completely.
Remove the lamp shade
Turn the defective LED bulb
Use a dry, lint-free cloth to replace a LED bulb
Insert a new LED bulb
Check for correct fitting.
Place the lamp shade
Reinsert the fuse or switch the circuit breaker back on.

Adjusting the motion sensor

Depending on the preadjustments of the motion sensor
itself on for a certain period of time as soon as the motion sensor
These preadjustments are made using the three controllers on the underside of the
motion sensor (see fig. J).
16
10 GB/CY
is correctly pasted on the connection housing
9
. Now carefully attach the wall plate
6
, attach the silicon washers
7
.
5
by releasing the locking screws
1
on the lamp body
1
with the crosshead screwdriver (see fig. I).
14
, first of all disconnect the product from the mains
15
from the lamp body
1
out of the socket with a ¼ turn anticlockwise.
15
in the socket and tighten it with a ¼ turn clockwise.
15
over the lamp body
1
, flat washers
3
from the lamp
14
and tighten it by fastening the
2
.
2
.
15
and screw tight.
2
, the product will switch
16
detects movement.
16
before
7
over the
6
and
4
15