Menu Features And Programming Instructions - Jacuzzi J-300 series Montageanweisung Und Bedienung Und Wartung

N.B.: The valve is designed to operate in positions A (Combo),
B, and C for optimum performance.
For optimum filtration benefits, leave the valve in position A
when spa is covered. Select position B or C for maximum jet
performance during spa use.
Adjusting Individual Jet Flow
The water flow to the individual jets in your spa can be increased
or decreased by rotating the outside jet face.
Many jets are also equipped with a direction adjustment mod-
ule, so that you can aim the jet in the desired position.
N.B.: always keep at least 6 of these jets open so as to ensure
efficient water filtering.
Adjusting PowerPro Jets
With the nozzles of the PowerPro Jets positioned straight a-
head, the jet stream will be stationary. Pushing the nozzle to one
side causes the jet nozzle to rotate, moving the jet stream in a
circular pattern.
The jets may not spin with the pump on low speed.
Waterfall feature
The waterfall feature allows you to independently control it for
a customized soothing effect. The waterfall is on when the cir-
culation pump is on. The JETS 1 or CLEARRAY buttons will al-
so activate the waterfall feature.
Waterfall Operation Details
A. Push thumb wheel on top of waterfall to the left (while in s-
pa) to start or increase flow.
B. Push thumb wheel on top of waterfall to the right (while in
spa) to slow or turn flow off.
NOTE: When the waterfall is in the OFF position, some wa-
ter could still flow through.
Air controls
Some jets have a dedicated air adjustment button. Press down
on the side with the Jacuzzi logo to open. Press the opposite side
to close the air.
To minimize heat loss, all air controls (side with Jacuzzi logo
up) should be closed when the spa is not in use.
Certain jets may not dispense air when pump 1 runs at low speed.
Spa Stereo System (optional)
Spas equipped with the optional Jacuzzi audio system offer en-
hanced enjoyment.

Menu Features and Programming Instructions

Your spa is equipped with five menus that allow you to program
additional features. By continually pressing the Menu button
you will cycle through the menus as follows.
Current temperature (Main Menu)
Primary Filtration Menu
Secondary Filtration Menu
CLEARRAY/UV Menu
Economy Menu
Lock Menu
I
Primary Filtration Menu
During the primary filtration cycle, the circulation pump and
CLEARRAY are activated. The spa is programmed with a facto-
ry default setting but can be programmed to any of the cycle set-
tings listed below. These cycles allow the circulation pump to run
for preset amounts of time per day, in addition to the normal op-
eration. Should the circulation pump activate outside of a pre-
set cycle (except for PF0 and PF6), e.g. when heating, that run
time will reduce the length of the next cycle.
Note: To set a time for the primary filtration cycle to begin, sim-
ply turn power on to the spa two minutes prior to the desired time.
You can also press the Warmer, Cooler and Jets Pump 1 buttons
simultaneously for 2 seconds to restart the spa once power has
been provided.
No filtration
4 hours of filtration per day
8 hours of filtration per day (default setting for
J-385)
12 hours of filtration per day
16 hours of filtration per day
20 hours of filtration per day
24 hours of filtration per day (default setting for
J-315)
2 hours of filtration – 4 times per day
3 hours of filtration – 4 times per day
27