Klarstein Steakreaktor 2.0 Bedienungsanleitung Seite 27

Instructions for location and operation
• Set the device on a stable, level and heat-resistant surface. Ensure that there is a
sufficient distance from strong heat sources such as hot plates, heating tubes and
such.
• Avoid heat build-up and place the unit in an area that allows heat occurring during
use of the device to dissipate.
• The feet also serve as spacers between the floor of the device and the surface upon
which it is placed. They must not be dismantled.
• The minimum distance on the sides of the device must be at least 15 cm. Above,
there must be a minimum distance of 50 cm.
• Be careful when roasting or toasting. We advise against the cooking of dry foods.
• Do not place the device under a wall cabinet or in a corner. Keep a safe distance
from flammable materials such as curtains or tablecloths.
• Keep the grill away from water. This is especially true when the oven is hot.
• Use only the accessories supplied or accessories available at www.klarstein.de for
operating the high-temperature grill.
• There are feet on the underside of the unit. Because furniture or floor surfaces
consist of various materials and are treated with various care products, it cannot
be completely ruled out that some substances may contain ingredients which can
corrode the device feet and soften them. If necessary, place a nonslip mat under the
feet.
• When cleaning do not use aggressive cleaning agents, abrasive cleaners, hard
sponges, etc.
• When cleaning, do not spray any liquids onto or into the unit. Use a slightly
moistened cloth with gentle cleaning agents.
Cleaning
Before first use, you should clean the appliance carefully to remove dust and possible
packaging and production residues. Afterward, heat the grill without food and clean
again.
• Clean all of the accessories in warm dishwater. Dry the parts thoroughly. Note that
aggressive cleaning agents can cause corrosion, even on stainless steel.
• Clean the outside and inside of the grill with a soft cloth slightly dampened with
water.
• Rub the oven thoroughly to dry.
• Plug the power cord into a socket with protective contact.
EN
27