Rma 339 C); Folding Down Dual Handlebar 40 (Rma 339); Central Cutting Height Adjustment - Stihl RMA 339 C Gebrauchsanleitung

● Removing:
Remove safety plug (2) from socket (3)
and keep separately from the lawn
mower.
Inserting:
Press safety plug (2) into socket (3) as
far as it will go.
● Close battery compartment cover (1).
9.3 Eco mode switch
The eco mode switch that increases
battery running time is located in the
battery compartment. ( 10.2)
Switching on eco mode:
● Move switch to position I.
Switching off eco mode:
● Move switch to position 0.
9.4 Adjusting mono handlebar

(RMA 339 C)

Danger of pinching!
When actuating the detent lever,
always hold the upper handlebar
with one hand at its highest point.
Never place your fingers between
the handlebar and console (over
and under the detent lever).
Folding down handlebar:
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Hold upper handlebar (2) with one hand
at its highest point and lift (relieve load)
slightly.
0478 131 9927 B - EN
● Press detent lever (1) downwards and
hold.
● Fold handlebar (2) down forwards,
ensuring that the electric cable is not
damaged.
Working position (to push machine):
● Fold handlebar (2) up rearwards and
ensure that handlebar is fully engaged.
Height adjustment:
13
The height of the mono handlebar can be
adjusted to 2 levels:
● Hold upper handlebar (2) with one hand
at its highest point and lift (relieve load)
slightly.
● Press detent lever (1) downwards and
hold.
● Move handlebar (2) into required
position.
● Release detent lever (1) and ensure
that handlebar is again fully engaged.
14
9.5 Folding down dual handlebar
(RMA 339)
Danger of pinching!
The upper handlebar can be folded
down when the rotary handles are
released. Therefore hold the upper
handlebar with one hand at its
highest point when unscrewing the
rotary handles.
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Loosen rotary handles (1) until they turn
freely.
● Fold down upper handlebar (2)
forwards.
Working position (to push machine):
● Fold up upper handlebar (2) rearwards
and hold with one hand.
● Tighten rotary handles (1). Make sure
that cable guide (3) is positioned
correctly.
9.6 Central cutting height
adjustment
Five cutting heights can be
selected.
Level 1 = 30 mm
Level 5 = 70 mm
Lawn mowers for Great Britain:
Six cutting heights can be selected.
Level S = 20 mm
Level 5 = 70 mm
In order to prevent damage, the
lowest cutting height must only be
used on even lawns (without
bumps).
15
Setting cutting height:
● 1 Push height adjustment lever (1)
away from the lawn mower slightly until
the lever is released from locating
lugs (2).
● 2 Raise or lower the lawn mower.
Increasing cutting height: Raise the
lawn mower using height adjustment
lever (1) (push lever forwards).
Decreasing cutting height:
Lower the lawn mower using height
adjustment lever (1) (push lever
rearwards).
16
49